Audia Flight

The Audia Flight Strumento N°1 MK2 stereo preamp is the perfect device to transmit the perfect signal with precision, dynamics and incredible speed (bandwidth over 1 MHz) to any power amplifier. During the creation, the engineers used the most accurate tool, human hearing, to help set up the circuits in the original Strumento N°1 (small but critical changes include the selection of resistor and capacitor ratings).

An amplifier with fully balanced circuitry has 48 solid-state elements in the output stages, 217 thousand UF of the total capacity of the filter capacitors in the power supply, a transformer rated at 3 kVA and has an impressive output power of 2000 watts at a load of 2 ohms (500 watts at 8 ohms).

An amplifier with fully balanced circuitry has 48 solid-state elements in the output stages, 217 thousand UF of the total capacity of the filter capacitors in the power supply, a transformer rated at 3 kVA and has an impressive output power of 2000 watts at a load of 2 ohms (500 watts at 8 ohms).

The rated power of the Audia Flight Three S is 100 watts per channel (at 8 ohms) or 160 watts per channel (at 4 ohms). These high values are achieved due to a powerful (600 VA) power transformer that supplies eight stabilized power sources: four high-current for output stages with a total capacitor capacity of 72,000 UF and four low-current for pre-stages with a total capacity of 13,200 UF.

The Audia Flight FLS-20 SACD player is encased in a rugged case with a thick aluminum front panel. Digital-to-analog conversion is implemented on two 32-bit Sabre ES9038PRO audiophile chips from ESS Technology. The circuit also uses an ultra-low-noise Crystek CCHD-950 clock generator. The digital circuits of the player are powered by ten linear power supplies, characterized by a low level of intrinsic noise.

The Audia Flight FLS-20 SACD player is encased in a rugged case with a thick aluminum front panel. Digital-to-analog conversion is implemented on two 32-bit Sabre ES9038PRO audiophile chips from ESS Technology. The circuit also uses an ultra-low-noise Crystek CCHD-950 clock generator. The digital circuits of the player are powered by ten linear power supplies, characterized by a low level of intrinsic noise.

The amplifier with fully balanced circuitry has 48 solid-state elements in the output stages, 217 thousand UF of the total capacity of the filter capacitors in the power supply, a transformer rated at 3 kVA and has an impressive output power of 2000 watts at a load of 2 ohms.

The Strumento N°4 MK2 Stereo Power Amplifier is a near—perfect dual-channel power amplifier that demonstrates incredible response speed, high output power, and virtually unlimited speaker control capabilities. For the mk2 version, experience in the development of the older model of the Strumento N° 8 monoblock power amplifier was used, as well as the results of live listening, which helped to further improve the original Strumento N°4 circuit (such small but important changes include the nominal values of resistors and capacitors).

The Strumento N°4 MK2 Stereo Power Amplifier is a near—perfect dual-channel power amplifier that demonstrates incredible response speed, high output power, and virtually unlimited speaker control capabilities. For the mk2 version, experience in the development of the older model of the Strumento N° 8 monoblock power amplifier was used, as well as the results of live listening, which helped to further improve the original Strumento N°4 circuit (such small but important changes include the nominal values of resistors and capacitors).

The Audia Flight FLS8 Mono power amplifier is characterized by exceptional responsiveness, huge output power (up to 800 watts 4 ohms) and an unsurpassed ability to effectively control and control speakers. Drawing inspiration from the famous Strumento series, the FLS8's design process included live listening sessions to achieve the goal of sonic perfection. This approach reflects the way an experienced craftsman uses years of experience, skill, and an astute ear to create instruments with perfect tonal character and emotional response.

Audia Flight FLS 4 is cast, made of aluminum alloy. The circuit design is fully balanced; 16 selected transistors and a power supply unit with capacitors with a total capacity of 288,000 UF are used.

According to the manufacturer, the phono corrector can be ordered with two MM inputs, with two MS and with MM and MS. If desired, the owner can later replace the replacement modules with the required ones. To adjust the corrector to the parameters of the heads, you need to remove the protective plate on the back panel — jumpers are found under it to adjust each channel of each of the inputs.

According to the manufacturer, the phono corrector can be ordered with two MM inputs, with two MS and with MM and MS. If desired, the owner can later replace the replacement modules with the required ones. To adjust the corrector to the parameters of the heads, you need to remove the protective plate on the back panel — jumpers are found under it to adjust each channel of each of the inputs.

Audia Flight FLS 10 is a whole storehouse of modern High-end solutions. Fully balanced circuit, 32 transistors, total capacitor capacity of 288,000 UF, toroidal transformer for 2,000 VA. The output power reaches 2 x 200 watts at 8 ohms, the device can operate at a load of up to 2 ohms.

Audia Flight FLS 10 is a whole storehouse of modern High-end solutions. Fully balanced circuit, 32 transistors, total capacitor capacity of 288,000 UF, toroidal transformer for 2,000 VA. The output power reaches 2 x 200 watts at 8 ohms, the device can operate at a load of up to 2 ohms.

The device is built according to the "double mono" scheme, the level adjustment is performed on separate boards for each of the channels. The power supply is based on as many as three fully shielded toroidal transformers. There is also a CPU circuit that provides for the possibility of disabling inactive inputs, adjusting sensitivity and gain (within 6 dB).

The Audia Flight CD Three S silver two-channel CD player is notable for its front-loading. The output stage of the device belongs to class A. There is a toroidal transformer, which plays an important role in the process of transforming the audio signal and obtaining the highest possible sound quality at the output. A remote control is also included with the player.

The Audia Flight CD Three S silver two-channel CD player is notable for its front-loading. The output stage of the device belongs to class A. There is a toroidal transformer, which plays an important role in the process of transforming the audio signal and obtaining the highest possible sound quality at the output. A remote control is also included with the player.

The main feature of the Audia Flight FLS 9 is the presence of two expansion slots in which optional modules can be installed. The manufacturer promises to offer in the form factor of such modules a DAC with digital inputs, a phono corrector for MM/MC heads with unbalanced switching and a module with two additional RCA inputs. A network streamer module should also be available in the near future.

The Strumento N°4 MK2 Stereo Power Amplifier is a near—perfect dual-channel power amplifier that demonstrates incredible response speed, high output power, and virtually unlimited speaker control capabilities. For the mk2 version, experience in the development of the older model of the Strumento N° 8 monoblock power amplifier was used, as well as the results of live listening, which helped to further improve the original Strumento N°4 circuit (such small but important changes include the nominal values of resistors and capacitors).

A 28 kg preamp with an energy consumption of 200 VA sounds proud! And when you find out that the total capacitance of the capacitors in the power supply is 60 thousand UF, then confusion creeps in at all: what is the preliminary in it? Nevertheless, the fact remains, and even more so