Sonus Victor GrandeLuna MarkII loudspeakers powered by a CH Precision M10 Stereo amplifier anchor this eight-component system, installed in a purpose-built room of about 60 m2 treated on every wall, the floor and the ceiling. Vinyl leads, with a TechDAS Air Force III Premium S carrying a Graham Engineering Phantom 3 arm in 9 inch form and a Dynavector DRT XV-1s cartridge, while the rest of the electronics come from the same Swiss maker.
The system at a glance
Eight boxes cover a turntable, arm and cartridge, a P10 phono stage, a C1.2 DAC, an L1 line preamplifier, the M10 and one pair of very large Italian speakers. This is a home reference installation aimed at an owner who listens mainly to records but keeps a full digital path. The C1.2 alone launched at about EUR 32,850, which sets the price level of the whole chain.
Why these components work together
The GrandeLuna MarkII is a sealed 4+3 way design about 2 m tall, quoted at 92 dB sensitivity and 4 ohm, with a range of 17 Hz to 30 kHz, and Sonus Victor recommends around 600 W of amplification. The M10 is a class AB amplifier rated at 300 W into 8 ohm, 550 W into 4 ohm and 900 W into 2 ohm, with twice the supply capacity of the M1.1 in a separate 78 kg power chassis, so the recommended power is available near the speaker's real load. The DRT XV-1s gives 0.3 mV from a 6 ohm coil. The P10 meets it with two current-sensing inputs below 100 milliohm, gain from +56 to +77 dB in 3 dB steps and a separate power supply chassis. The Phantom 3 is a unipivot arm with Graham's Stable Balance system, and the Air Force III Premium S lifts its 29 kg gunmetal platter on a cushion of air. The L1 is a discrete, dual-mono class A line stage with a 20 bit R-2R ladder volume in 0.5 dB steps. The C1.2 uses four PCM1704 R-2R converters per channel and upsamples PCM to 705.6 or 768 kHz.
How it sounds
With a large amplifier holding the low impedance of a sealed enclosure, the bass reaches deep and stops cleanly, without the overhang a port can add. The treated room lets the large driver array build a wide and deep stage, and orchestral and organ recordings keep their scale without strain at realistic levels.
Considering a similar setup
The speaker defines everything. Whatever drives the GrandeLuna MarkII must deliver hundreds of watts into 4 ohm and below, so the M10 can later be bridged as a pair of monoblocs. The front end scales more easily, provided low-output coils still get a current-sensing phono input.
by TechDAS
With total moment of inertia 3,506 kg / cm2 and Wow & Flutter below 0.03% TechDAS Air Force III Premium S offers extraordinary sound.
Stable Balance unipivot reference-class tonearm - an upgraded version of the highly-rated Phantom II.
by Dynavector
Low output moving coil cartridge with multi Alnico magnets and the Flux damper offers clear and detailed sound.
by CH Precision
Dual monaural twin-chassis High End class phonostage - the latest introduction to CH Precision flagship 10 Series.
by CH Precision
Upsampling DAC with volume control and Linearized R-2R with four PCM1704 chips per channel offers PCM 24 bits, 705.6kHz or 768kHz, DSD via DoP up to DSD512.
by CH Precision
Fully discrete, balanced Dual Monaural line-stage (preamplifier) with heavily regulated and filtered power supplies and extreme wide-bandwidth frequency responses.
by CH Precision
Doubled the power supply capacity (vs. M.1.1) High End amp offers bandwidth up to 500kHz and delivers 2 x 550 Wt (4 Ohms load)!
by Sonus Victor
Sealed box High End loudspeaker system 4+3 way with wide frequency response (17 - 30 000 Hz).