The G Two is a compact two-way active loudspeaker in Genelec's Home Audio range, positioned above the G One. Genelec names music, home theatre, TV and computer sound as its applications. Its amplifiers are contained within the cabinet, and the speaker is offered in White, Black and RAW versions.
Key specs that matter
A 105 mm cone bass driver and a 19 mm metal dome treble driver are crossed over at 3.0 kHz, and each is driven by its own 50 W class D amplifier. Frequency response is 56 Hz - 25 kHz (-6 dB), and accuracy is ±2.5 dB from 62 Hz to 20 kHz. Genelec specifies maximum short-term sine wave output of 100 dB SPL or more (on axis in half space, averaged 100 Hz - 3 kHz at 1 m) and maximum long-term RMS output of 93 dB SPL or more. Self-generated noise is 5 dB SPL or less. At 85 dB SPL, harmonic distortion is below 3% from 50 to 200 Hz and below 0.5% above 200 Hz. Amplifier THD+N at nominal output is below 0.05%. Its single RCA female input has an impedance of 10 kOhm. Power consumption is 0.5 W or less in ISS standby, 3 W idle and 60 W at full output, from 100-240 V AC. With the Iso-Pod it is 242 mm high (230 mm without), 151 mm wide and 142 mm deep, and it weighs 3.2 kg.
Engineering and use context
Its reflex-loaded enclosure is die-cast aluminium, made in two parts, front and rear. Genelec calls it a Minimum Diffraction Enclosure (MDE), with rounded edges and a curved front, and the Directivity Control Waveguide (DCW) is integrated into it. Long-term output power is limited by the driver unit protection circuitry.
Rear-panel tone controls are Tabletop (-4 dB at 200 Hz), Bass (0 to -6 dB at 100 Hz in 2 dB steps) and Low Bass (a -4 dB step at 65 Hz). A LEVEL -10 dB switch reduces input sensitivity, and an LED OFF switch turns off the power indicator. With Intelligent Signal Sensing (ISS) active, the speaker goes into standby when playback has ended and resumes once an input signal is detected. Setting the ISS switch disables this function, and the speaker is then switched with the mains power switch only.
Each G Two sits on an Iso-Pod (Isolation Positioner/Decoupler), a vibration-insulating table stand that allows the cabinet to be tilted. A threaded hole in the base is compatible with a standard microphone stand, and the rear has threaded holes for Omnimount brackets. Supplied with each speaker are a 1.8 m mains cable, the operating manual and an Iso-Pod kit.
Pairing
A line-level source such as a preamplifier or a computer sound card is required. Speaker-level outputs of a power amplifier must not be connected. Genelec's F Series subwoofers are the matching subwoofers.
Alternatives
The G Three is the next Genelec Home Audio model, with a 130 mm bass driver and an added XLR input.