The 4020C is a bi-amplified two-way active loudspeaker from Genelec's 4000 series, which the Finnish company designs for fixed installations in commercial spaces. As an active loudspeaker it contains the drivers, power amplifiers, active crossover filters and protection circuitry. The C version replaced the 4020B, which was built from 2013 to 2017.
Key specs that matter
Drivers are a 105 mm cone bass driver and a 19 mm metal dome treble driver, both magnetically shielded. Amplifier output power is 50 W for bass and 50 W for treble (Class D), with amplifier system THD below 0.05% at nominal output. Crossover frequency is 3.0 kHz. Frequency response is 56 Hz - 25 kHz (-6 dB) and 62 Hz - 20 kHz (±2.5 dB). Maximum short term SPL is above 100 dB, long term SPL above 93 dB, and peak output per pair above 107 dB (1 m). Harmonic distortion at 85 dB SPL is below 3% from 50 to 200 Hz and below 0.5% above 200 Hz. Input is a balanced 3-pin Euroblock at 10 kohms. Dimensions are 226 x 151 x 142 mm (H x W x D), and weight is 3.1 kg.
Engineering and use context
Genelec's Minimum Diffraction Enclosure (MDE) is die-cast aluminium, shaped with rounded edges and a gently curved front and sides to reduce edge diffraction. The die-casting is made in two parts, front and rear, and the aluminium walls also act as a heat sink for the power amplifiers. A Directivity Control Waveguide (DCW) is integrated into the enclosure, and the bass is reflex-loaded.
On the rear panel, a level control gives a continuously variable range of -40 dB, and input level for 100 dB SPL at 1 m is -6 dBu. Treble Tilt adds +2 dB above 4 kHz. Bass Tilt attenuates below 2 kHz from 0 to -6 dB in -2 dB steps, and Bass Roll-Off is a -4 dB step at 65 Hz. With the ISS switch on, the speaker goes to standby after playback ends and resumes when a signal is detected. Consumption is below 0.5 W in ISS standby, 3 W at idle and 60 W at full output, from 100 - 240 V AC mains.
For mounting, the base has a UNC threaded hole for a standard microphone stand, and the rear has two M6x10 mm threaded holes for Omnimount size 20.5 brackets. A 3-position terminal block, a 1.8 m mains cable, a simple keyhole wall bracket and a mounting screw set come in the box. Standard finishes are black and white, with 120 RAL colours and unpainted RAW aluminium available.
Pairing
A balanced line-level source is required, such as a mixer, matrix processor or preamplifier. The plug accepts a second signal cable for daisy-chaining further speakers. Genelec states that the 4020C must never be connected to the loudspeaker outputs of a power amplifier, integrated amplifier or receiver.
Alternatives
The 4030C is the next size up in the 4000 series, with a 130 mm bass driver and a lower cut-off of 47 Hz (-6 dB).