The 4040A is the largest model and the flagship of Genelec's 4000 series of active installation loudspeakers. Genelec designed it for larger fixed installations that demand higher playback levels and greater low-frequency extension, and lists theatres, restaurants, conference rooms, museums, art galleries and sport centres as applications. It is a bi-amplified two-way design, with the drivers, power amplifiers, active crossover filters and protection circuitry inside one enclosure. Indoor use is specified, at 15 - 35 °C and 20 - 90% relative humidity.
Key specs that matter
Drivers are a 165 mm cone woofer and a 19 mm metal dome tweeter, with the crossover at 2.5 kHz. Each driver has its own 120 W Class AB amplifier (short-term output power). Frequency response is 55 Hz - 20 kHz (±3 dB), with -6 dB points at 50 Hz and 25 kHz. Maximum short-term SPL is 109 dB or more and long-term SPL 101 dB or more (1 m, half space). Self-generated noise is 10 dB or lower (A-weighted, 1 m). Harmonic distortion at 90 dB SPL is below 3% from 50 to 100 Hz and below 0.5% above 100 Hz. Power consumption is 0.5 W or less in ISS standby, 15 W or less at idle and 170 W at full output. Dimensions are 350 x 237 x 223 mm (H x W x D), and weight is 9.9 kg.
Engineering and use context
Its Minimum Diffraction Enclosure (MDE) is die-cast aluminium, shaped to reduce edge diffraction and combined with a Directivity Control Waveguide (DCW) around the tweeter. Bass loading is a reflex port. Audio input is a 10 kOhm balanced Phoenix connector, which also carries two pins for a 12 V trigger voltage. A remote signal on those pins overrides the Autostart function. Input level for 100 dB SPL at 1 m is adjustable from +6 to -6 dBu with a rotary control on the rear panel.
Rear-panel switches set Bass Roll-Off from 0 to -6 dB at 55 Hz, Bass Tilt from 0 to -6 dB at 100 Hz and Treble Tilt from +2 to -4 dB at 15 kHz, all in 2 dB steps, and both tilt controls also have a mute position. Autostart triggering voltage is about 0.4 mV or 1.4 mV, and a second switch shortens the Autostart off time to 15 minutes. LED Off turns off the green power indicator, while the red overload LED stays active.
On the back are two sets of M6x10 mm threaded holes for Omnimount Series 30 and König & Meyer mounts or the supplied keyhole wall mount, and an M10x10 mm threaded hole sits in the base. Finishes are black, white, RAW and 120 RAL colours.
Pairing
A balanced line-level source is required. The 4040A must never be connected to the loudspeaker outputs of a power amplifier, integrated amplifier or receiver. Its trigger pins accept a remote mains-switching signal from a control system.
Alternatives
The Genelec 4030C is the next smaller 4000 series installation loudspeaker, with a 130 mm woofer.