The 4410A is the most compact loudspeaker in Genelec's Smart IP family of networked installation speakers, announced in March 2022 to join the 4420A and 4430A. It is a bi-amplified two-way active design for fixed installations and needs only one CAT cable, which carries power, audio and control. Power comes from standard Power over Ethernet, PoE+ or PoE. Inside are a dedicated Class D amplifier for each driver, a switched-mode power supply, an active crossover filter, electronic system protection and an audio-over-IP input.
Key specs that matter
A 76 mm cone woofer and a 19 mm metal dome tweeter are crossed over at 2.9 kHz, with 18 W Class D short-term amplifier power per driver. Frequency response is 74 Hz - 20 kHz (±2.5 dB), with -6 dB points at 67 Hz and above 40 kHz. With PoE+ power, maximum short-term SPL is 96 dB or more, long-term SPL 91 dB or more and peak SPL above 100 dB (1 m). Self-generated noise is 5 dB or lower (A-weighted, 1 m). Harmonic distortion at 80 dB SPL is below 3% from 70 to 200 Hz and below 0.5% above 200 Hz. Dispersion is 130° horizontal and 110° vertical. Power consumption is 3 W in ISS standby, 4 W at idle and 30 W at full output. Dimensions are 181 x 121 x 115 mm (H x W x D), and weight is 1.5 kg.
Engineering and use context
Its single RJ45 connection is 100BASE-TX Ethernet and accepts AES67, ST2110-30 and Dante streams at 32 - 96 kHz and 16 - 24 bit. Each speaker reproduces one channel or the sum of two. Supported power standards are PoE+ (IEEE 802.3at, Class 4, 30 W at the switch) and PoE (IEEE 802.3af, Class 3, 15.4 W), and Genelec recommends PoE+, because lower PoE power limits maximum SPL. CAT 5, 5e or 6 cable may run up to 100 m.
Genelec's Minimum Diffraction Enclosure (MDE) is made of recycled die-cast aluminium to reduce diffraction, with a Directivity Control Waveguide (DCW) around the tweeter and a reflex port. Internal DSP gives 20 user-adjustable filters - parametric notch, high and low shelf, bass roll-off, bass tilt and treble tilt. Notch gain runs from -20 to +2 dB, Q from 0.1 to 20 and centre frequency from 10 Hz to 16 kHz. Sensitivity adjusts from -60 to 0 dB and delay from 0 to 98 ms. Installers set these up in Smart IP Manager software, where each zone can hold up to five profiles, and an API allows third-party control.
Rear M6 x 8.5 mm threaded holes take brackets or the supplied keyhole wall mount, and a 3/8 UNC hole sits in the base. Finishes are black, white, RAW and RAL colours.
Pairing
An IP switch with a PoE+ output, or a PoE+ power injector, is required. The audio source is an AES67, ST2110 or Dante stream, set up in Dante Controller. There is no analogue input.
Alternatives
The Genelec 4420A is the next larger Smart IP model, with a 105 mm woofer and a balanced analogue input.