Genelec's 4030C is a bi-amplified two-way active loudspeaker for fixed installations and sits between the 4020C and 4040A in the 4000 series. The maker names small to medium-sized commercial installations as its field, with clubs, bars, restaurants, boardrooms, museums and theatres given as examples. Drivers, power amplifiers, active crossover filters and protection circuitry are all inside the cabinet, and the operating manual of the C version is dated February 2017.
Key specs that matter
A 130 mm cone bass driver and a 19 mm metal dome treble driver are used. Each has a 50 W Class D amplifier, and amplifier system THD is below 0.05% at nominal output. Crossover frequency is 3.0 kHz. Frequency response is 47 Hz - 25 kHz (-6 dB) and 54 Hz - 20 kHz (±2 dB). Maximum short term SPL is above 104 dB, long term SPL above 96 dB, and peak output per pair above 110 dB (1 m). Harmonic distortion at 85 dB SPL is below 2% from 50 to 100 Hz and below 0.5% above 100 Hz. The input connector is a balanced 10 kohm 3-pin Euroblock. Dimensions are 285 x 189 x 178 mm (H x W x D), and weight is 4.9 kg.
Engineering and use context
Its Minimum Diffraction Enclosure (MDE) is made of die-cast aluminium and shaped to reduce edge diffraction, with rounded edges and a curved front baffle. Genelec casts it in two parts, front and rear, and the walls serve the power amplifiers as a heat sink. Integrated into this enclosure is the Directivity Control Waveguide (DCW) around the tweeter. Low-frequency loading is a reflex port.
Room response controls on the rear are Treble Tilt (+2 dB above 5 kHz), Bass Tilt (0 to -6 dB at 100 Hz in -2 dB steps) and Bass Roll-Off (-4 dB at 55 Hz). A level control is continuously variable over -40 dB, and -6 dBu gives 100 dB SPL at 1 m. When the ISS switch is on, the 4030C powers down to standby after playback ends and resumes once an input signal is detected. Power consumption is below 0.5 W with ISS active, 3 W at idle and 60 W at full output. Mains voltage is 100 - 240 V AC, 50 - 60 Hz.
Mounting points are a UNC threaded hole in the base for a standard microphone stand and two M6x10 mm threaded holes on the rear for Omnimount size 20.5 brackets. Supplied with it are a 3-position terminal block, a 1.8 m mains cable, a keyhole wall bracket and a mounting screw set. Finishes are black, white, 120 RAL colours and RAW aluminium.
Pairing
A balanced line output from a mixer, matrix or preamplifier is required. A second cable on the terminal plug daisy-chains the signal to the next speaker. Loudspeaker outputs of power amplifiers, integrated amplifiers and receivers must not be connected.
Alternatives
The 4040A is the larger 4000 series model, with a 165 mm bass driver and a 120 W Class AB bass amplifier.