The G One is a compact two-way active loudspeaker from Genelec of Finland and the most compact model in the company's Home Audio range. Its amplifiers are contained within the speaker cabinet, and a line-level source is connected to it directly. Genelec lists the current G One (B) in White, Black and RAW versions.
Key specs that matter
Drivers are a 76 mm cone bass driver and a 19 mm metal dome treble driver, crossed over at 3.0 kHz. Each has its own 25 W class D amplifier. Frequency response is 67 Hz - 25 kHz (-6 dB), with an accuracy of ±2.5 dB from 74 Hz to 20 kHz. Maximum short-term sine wave output is 96 dB SPL or more (on axis in half space, averaged 100 Hz - 3 kHz at 1 m), and maximum long-term RMS output is 91 dB SPL or more. Self-generated noise is 5 dB SPL or less (A-weighted, 1 m). Harmonic distortion at 85 dB SPL is below 3% from 70 to 400 Hz and below 0.5% above 400 Hz, and amplifier THD+N at nominal output is below 0.08%. A single RCA female input has an impedance of 7 kOhm. Power consumption is 0.5 W or less in ISS standby, 5 W idle and 30 W at full output, from 100-240 V AC. Height is 195 mm on the Iso-Pod (181 mm without it), width 121 mm, depth 115 mm and weight 1.7 kg.
Engineering and use context
Genelec die-casts the reflex-loaded enclosure from recycled aluminium, with the port on the rear. This Minimum Diffraction Enclosure (MDE) has rounded edges and a gently curved front, and a Directivity Control Waveguide (DCW) is integrated into it around the tweeter. Long-term output power is limited by the driver unit protection circuitry. It reduces the output level when the voice coil temperature reaches its safe limit.
On the rear panel sit a Tabletop switch (-4 dB at 200 Hz), two Bass switches giving 0 to -6 dB at 200 Hz in 2 dB steps, a LEVEL -10 dB switch and an ISS DISABLE switch. With all switches off, the factory setting gives a flat free-field response. Intelligent Signal Sensing (ISS) puts the speaker into a low-power sleep state when no input is detected for a period of time and turns it on again when a signal arrives. With ISS DISABLE set to on, it is switched only by the mains power switch.
Its Iso-Pod table stand is made of a lossy rubber-like material and allows a tilt of ±15 degrees. A threaded hole in the base accepts a standard microphone stand, and threaded holes on the rear are for Omnimount brackets. Each speaker comes with a 1.8 m mains cable, the operating manual and the Iso-Pod kit.
Pairing
A line-level source such as a preamplifier or computer sound card is required. The speaker terminals of a power amplifier must not be connected. Each speaker needs its own mains outlet.
Alternatives
The G Two is the next Genelec Home Audio model, with a 105 mm bass driver and two 50 W class D amplifiers.