The Euterpe Jubilé is a two-way floorstanding loudspeaker from Jean-Marie Reynaud (JMR), the French loudspeaker maker in Barbezieux, Charente. Like the Abscisse Jubilé, it is a thorough redesign of an earlier model, the Euterpe. JMR kept the loading principle and the cabinet volume of the original, replaced the bass-midrange driver and the tweeter and redesigned the whole crossover. Its listed price is EUR 3,250.
Key specs that matter
Nominal impedance is 4 ohms (minimum 4.3 ohms), and frequency response is 38 Hz - 25 kHz. Sensitivity is 89 dB/W/m. Power handling is 80 W, with 160 W peak, and recommended amplifier power is 40 - 120 W. Distortion is below 0.5% (84 dB). The crossover has 12/12 dB per octave slopes at 2.8 kHz. Connection is single-wire. Dimensions are 92 x 20 x 33 cm (H x W x D), and weight is 26 kg.
Engineering and use context
JMR specifies a tuned triangular line with no parallel internal walls and a minimum of absorbent material. Viscoelastic absorbers inside the cabinet convert vibrational energy into heat. The tweeter is installed in an isolated volume, away from mechanical intermodulation with the woofer.
A threaded stainless steel (non-magnetic) rod runs through the cabinet from the woofer's magnet to the rear panel. Its tension is set with a precision torque wrench, and this axial fixing puts the cabinet walls under tension and spreads mechanical stress evenly between the driver chassis and the baffle. According to JMR, this improves the transient response of the system.
Made to JMR specification, the 170 mm bass-midrange driver has a long-fibre paper cone with a Gaussian profile, treated on its inner face with an absorbent material. Its impregnated fabric dust cap is assembled at the back of the cone. Other details are a 28 mm voice coil on a vented aluminium former, a double magnet and a rubber-foam surround with a progressive profile. Shared with the Cantabile Jubilé, the tweeter is a 28 mm impregnated silk dome with a neodymium magnet, bonded to a waveguide machined from solid aluminium, and no phase plug is used.
In the crossover JMR uses low-resistance air-core inductors wound with 1.5 mm pure copper wire and silver-foil capacitors paired to 1% tolerance. Wiring is point-to-point with JMR HP1132 silver cable, and the network sits on an anti-vibration support. A wide fillet along the rear horizontal edge marks the Jubilé styling. Finishes are cherry-stained aniegre, satin black, pearl white and anthracite grey.
Pairing
An amplifier rated into 4 ohms is required. The WBT-type terminals allow single-wiring only. JMR recommends its HP1132 speaker cable.
Alternatives
The Abscisse Jubilé is a larger JMR floorstanding speaker of the same Jubilé range.