The ORFEO GRANDE is a floorstanding loudspeaker from the French manufacturer Jean-Marie Reynaud (JMR). It sits above the ORFEO JUBILE in the range without replacing it, and its cabinet, crossover and drivers were all revised from that model. Finishes are two-tone, in Metallic Grey, Pearl White, Anthracite Grey or Midnight Blue.
Key specs that matter
It is a 2.5-way design with an AST aerostriction tweeter and two 180 mm bass-midrange drivers. Crossover slopes are 6/12/12 dB per octave, with crossover points at 200 Hz and 2.2 kHz. Frequency response is 30 Hz - 25 kHz (±3 dB). Sensitivity is 91 dB/W/m (2.83 V), and impedance is 4 ohms (3.9 ohms minimum). Recommended power is 90 - 300 W, with 400 W on repetitive peaks. Distortion is below 2% from 200 Hz to 18 kHz at 85 dB. Dimensions are H 118, W 24, D 33 cm (plinth 30 x 39 cm), and weight is 45 kg per speaker.
Engineering and use context
The tweeter has a pleated diaphragm 25 mm wide and 60 mm high, on a silicone support coated with a thin aluminium film and surrounded by two neodymium bars. It works on the Heil or AMT principle and squeezes the air between its pleats instead of pushing it like a ribbon.
Each bass-midrange cone is made of 7 layers of carbon fibre and PEEK with a plasma treatment on its outer surface. A 37 mm two-layer voice coil sits on a ventilated fibreglass former, and a pure copper ring linearises the impedance at the top of the band. Stainless steel threaded rods press on each magnet assembly and are tensioned against the rear wall of the cabinet. Both drivers work in tandem and in phase in the bass, where the lower one rolls off at 6 dB per octave, while the upper one is not filtered in the bass.
JMR builds the crossover by hand without a printed circuit board, in two separate cells, with no resonant or trap circuits. Components are matched in pairs to a 1% tolerance. Wound tweeter equalisation resistors sit inside a copper tube, and a fifth terminal grounds the crossover. ETI binding posts of silver-plated tellurium copper are used.
Bass loading is a triangular line tuned in 1/4 wave, leading to a front vent at the bottom of the cabinet. A 3 mm aluminium sheet wraps three faces of the MDF cabinet, and bitumen and viscoelastic compound line much of its inner surface. Its plinth is fully decoupled and stands on Teflon pads instead of spikes.
Pairing
An amplifier stable into 4 ohms is required. The terminals allow bi-wiring or passive bi-amping. Its fifth terminal connects to the mains earth, not to the amplifier ground.
Alternatives
The ORFEO JUBILE is the related JMR floorstanding loudspeaker, a 2.5-way design 116 cm high and weighing 40 kg.