Hifiverse

Bookshelf Speakers — ATC SCM150ASL Pro

Description, images, technical data and specifications

ATC SCM150ASL Pro
Image source - (c) ATC

ATC's SCM150ASL Pro is an active three-way monitor in the company's professional range, used as a main or farfield system in larger control rooms. Its cabinet has an internal volume of 150 litres. Drive units and amplifier electronics are designed and built by ATC at its works in Gloucestershire. In the model name SL denotes Super Linear Magnet technology and A denotes built-in amplification.

Key specs that matter

Three ATC drivers are used - a 25 mm S-Spec dual-suspension tweeter, a 75 mm Super Dome midrange and a 375 mm full-specification SL bass driver. Amplification is a grounded source tri-amp pack rated at 350 W, with 200 W LF, 100 W MF and 50 W HF continuous, one amplifier per driver. Amplitude linearity is ±2 dB from 60 Hz to 17 kHz, and cut-off frequencies are 25 Hz and 25 kHz (-6 dB, free standing). Maximum continuous SPL reaches 117 dB at 1 m. Coherent dispersion is ±80° horizontally and ±10° vertically. Each cabinet measures 884 x 498 x 648 mm (H x W x D) including the rear amplifier and weighs 75 kg.

Engineering and use context

Active crossover points sit at 380 Hz and 3.5 kHz, with 4th order critically damped filters and phase compensation. Every amplifier pack receives frequency, gain and phase correction individually optimised at the ATC factory, and matched response is ±0.5 dB. ATC attributes low distortion at all levels partly to Super Linear technology and underhung voice coil construction.

Protection consists of active peak momentary gain reduction on all three channels and an r.m.s. power limiter on the HF channel. On the front panel are a power-on indicator and a gain reduction warning. Two rear trims are continuously variable - input sensitivity from 0 to -6 dB and an LF contour adding 0 to +6 dB at 40 Hz. As supplied, the monitors are calibrated to 1 V input sensitivity, and ATC warns that adjusting either trim without the ability to recalibrate leaves a pair out of step. Mains voltage is internally set to 100, 115 or 220 - 230 V (50/60 Hz). Veneers are Black Ash, Mahogany, Cherry and Natural Oak. A returned warranty card extends cover to six years.

Pairing

Its balanced female XLR input has 10 kohm per leg and needs 1 V rms (0 dBV/1.1 dBu) for full output. A console, monitor controller or preamplifier with balanced line outputs is required. Each speaker takes a mains cable and a signal cable.

Alternatives

The ATC SCM100ASL Pro is the smaller three-way active monitor with a 314 mm bass driver and 115 dB maximum continuous SPL.

Specifications

  • Model name

    SCM150ASL Pro

  • Frequency Response low +/- 3dB (Hz)

    25 (-6dB)

  • Frequency Response high +/- 3dB (Hz)

    25 000 (-6dB)

  • Sensitivity (dB at 1 W/1m)

    N/A

  • Impedance (Ohms)

    N/A

  • Power amplifier requirements (W)

    N/A

  • Has internal amplification

    Yes

  • Internal amplification power (W)

    50 + 100 + 200

  • Size (sm)

    88.4 x 49.8 x 56.8

  • Weight (kg)

    75

  • Official link

More components