The F1-5 is the bookshelf model of the F1 series, the top range of Fyne Audio. It takes the same technology as the larger F1-8 floorstanding speaker into a compact cabinet. F1 models are designed, manufactured, hand finished and tested at the company's facility in Glasgow. The only finish is Piano Gloss Walnut, real walnut veneer with burr walnut inlays on the front and top. Fyne lists the pair at GBP 4,299.98 including VAT.
Key specs that matter
System type is 2-way reflex, with a port venting downwards onto the BassTrax Tractrix diffuser. A 125 mm IsoFlare point source driver with a multi-fibre bass/midrange cone and FyneFlute surround carries a 19 mm magnesium dome compression tweeter with a neodymium magnet system. Crossover frequency is 1.9 kHz. The network is single wired, passive and low loss, with a 2nd order low pass and a 1st order high pass. An HF output control on the front baffle gives ±3 dB adjustment in the 2.5 kHz - 5.0 kHz band. Sensitivity is 87 dB (2.83 V/1 m), and nominal impedance is 8 ohms. Frequency response is 48 Hz - 38 kHz (-6 dB, typical in room). Recommended amplifier power is 30 - 100 W RMS, continuous power handling is 50 W RMS and peak power handling is 200 W. Dimensions are 321 x 186 x 289 mm (H x W x D), and net weight is 5.7 kg.
Engineering and use context
In the IsoFlare driver the bass/midrange cone shares a common centre with the high frequency unit. Fyne states that energy is radiated isotropically with constant directivity from a single point, giving a time-aligned wavefront. On standmount F1 models the FyneFlute surround terminates cone energy.
Its cabinet is high density pressed birch plywood with extensive internal bracing, and it sits on a machined aluminium plinth. BassTrax uses a twin cavity design with a tuned waveguide port in the reinforced lower panel. According to Fyne, this broadens the tuning frequency to reduce cone excursion. Housed in the plinth, the Tractrix profile diffuser converts the LF output of the lower cavity port into a horizontally expanding 360-degree wavefront.
Each crossover is hand built on vibration damping fibreboard panels. Components include LF laminated core inductors, non-inductive thick film resistors and Claritycap HF polypropylene capacitors, with Neotech PC-OCC internal wiring. After assembly and testing every F1 crossover receives Deep Cryogenic Treatment.
Pairing
An amplifier rated for 8 ohm loads within the recommended power range is required. Stands are not supplied, and the matching F1 series stand is the FS8.
Alternatives
The F701SP is the standmount speaker of the Fyne Audio F700SP series.