The 8010A is the smallest model in the Genelec 8000 series of active two-way studio monitors. Genelec names bedroom studios, hotel rooms and OB vans among its places of use. It is available in dark grey, white, black and an unpainted RAW aluminium finish.
Key specs that matter
Drive units are a 76 mm cone bass driver and a 19 mm metal dome tweeter. Amplification is 25 W Class D for the bass and 25 W Class D for the treble, with the crossover at 3 kHz. Frequency response is 67 Hz - 25 kHz (-6 dB), and accuracy is ±2.5 dB from 74 Hz to 20 kHz. Short-term maximum SPL is ≥96 dB (sine wave, on axis in half space, averaged 100 Hz - 3 kHz, 1 m), peak SPL per pair is ≥105 dB with music material at 1 m, and long-term maximum SPL is ≥91 dB. Harmonic distortion is ≤3% from 70 to 400 Hz and ≤0.5% above 400 Hz. Self-generated noise is ≤5 dB SPL (A-weighted, 1 m). Height is 181 mm, or 195 mm with the Iso-Pod, width 121 mm, depth 115 mm, and weight 1.5 kg.
Engineering and use context
Genelec uses its Minimum Diffraction Enclosure (MDE) here, a die-cast aluminium cabinet with rounded edges and gently curved front and sides. It is die-cast in two parts, front and rear, and its thin walls also give EMC shielding and act as a heat sink for the power amplifiers. Polyester fibre material (PES) is used for internal damping. A Directivity Control Waveguide (DCW) is integrated into the enclosure around the tweeter, and the cabinet is reflex-loaded through a curved tube that ends in a wide flare on the rear.
Each driver has its own amplifier after an active crossover operating at low signal levels. Protection circuitry reduces the signal level on sudden peaks or sustained excessive drive. With Intelligent Signal Sensing (ISS) active, the monitor drops into a sleep state at ≤0.5 W when no audio is present and switches on again when a signal is detected, and an ISS Disable switch on the back plate turns this off. Idle consumption is ≤5 W and full-output consumption 30 W, from 100-240 V AC, 50/60 Hz mains. Rear-panel room response switches adjust the bass and treble balance.
The Iso-Pod is a stand of lossy rubber-like material with four shallow feet, attached to the enclosure and slid along its curved surface for a ±15° tilt. A mains cable of 1.8 m, the operating manual and the Iso-Pod kit come in the box, and the warranty is two years, extended by three years on registration with MyGenelec.
Pairing
A source with a balanced line output is required, and the input is a female XLR with 7 kOhm impedance. Genelec accessories include the 8000-437 VESA adapter and a soft carrying case for two monitors.
Alternatives
The Genelec 8020D is the next model up in the 8000 series, with a 105 mm bass driver and 50 W Class D amplifiers.