The M-5000 TITAN from Allnic Audio is a mono tube power amplifier in a parallel push-pull layout with eight KT150 beam tetrodes in each unit. Its successor is the M-10000 Signature of 2025, which Allnic presents as a complete redesign of the TITAN with eight KT170 tubes per channel. Once sold in black and in silver, the TITAN has since been withdrawn from production.
Key specs that matter
Each monoblock delivers 400 W into 8 ohm at 1 kHz in pentode mode and 125 W in pure triode mode. Voltage gain is 24 dB, and a 2.0 V signal is needed for rated power. Input impedance is 100 kOhm, with one RCA and one XLR socket on every chassis. Allnic quotes 0.17% distortion at 1 kHz and 10 W, a flat response from 20 Hz to 20 kHz, 80 dB of signal-to-noise (CCIR, 1 kHz) and a damping factor of 8 into an 8 ohm load at 1 kHz.
Engineering and use context
A single 5749 tube forms the first gain stage. Two E55L (8233) tubes follow as second-stage drivers, wired as triodes and working into a load of about 450 ohm. Switching between pentode and triode connection of the KT150 bank takes place on the fly, without turning the amplifier off. The output transformers have large nickel and FeSi cores of 114 mm. Allnic calls them Full Engagement transformers - four independent secondary windings stay connected at all times, whichever output tap the owner uses, and none of the copper sits idle. Speaker terminals come as 4 and 8 ohm taps as standard, or as 8 and 16 ohm taps on factory order. A soft-start circuit applies the high voltage to the plate of each tube only after the heaters have warmed up. Every KT150 has its own analogue current meter and bias knob on the chassis, and every output tube is protected by a separate 20 mm slow-blow fuse rated at 0.5 A and 250 V, while a 5 A fuse of the same type guards the IEC mains inlet.
Pairing
With several hundred watts available per channel in pentode mode, the TITAN can drive large, low-sensitivity floorstanding speakers that defeat smaller tube amplifiers. The triode setting cuts output to less than a third and is the logical choice for efficient horn or wide-range designs. The input stage wants a line stage that can swing a full 2 V, ideally over XLR, and the choice of output taps should follow the nominal impedance of the speakers.
Alternatives
The Allnic M-3000 MK3 is a smaller mono power amplifier with KT170 output tubes and a 240 W pentode rating.