The M-3000 mk3 is the third generation of the tube monoblock that Allnic Audio first launched with KT120 tubes. The MK1 produced 140 W from them, the MK2 of 2016 moved to four KT150 tubes and 200 W into 8 ohm, and the mk3 arrived seven years later with a new output tube, larger transformers and a revised driver stage. Allnic itself says the changes go so deep that the mk3 is almost a different model. The list price for a pair was USD 30,000.
Key specs that matter
Four KT170 tubes per chassis run in parallel push-pull. In beam pentode mode each amplifier delivers 240 W into 8 ohm, and switching to triode mode gives 120 W. Voltage gain is 28 dB, input sensitivity is 2 V, and both XLR and RCA inputs present 100 kohm. Allnic quotes a response of 20 Hz to 20 kHz within 3 dB, 80 dB of signal-to-noise, a damping factor of 8 into 8 ohm at 1 kHz and distortion plus noise of 0.17 percent at 1 kHz and 10 W. Each chassis measures 430 x 460 x 270 mm and weighs 36 kg.
Engineering and use context
The KT170 is a Tung-Sol beam tube released in 2020, which Allnic had already used in the T-2000 30th Anniversary integrated amplifier in 2021. It is physically larger than the KT150, and its plate dissipation rises from 70 W to 85 W, which is what allows the higher output. Per channel the signal runs from one 5654 pentode at the input to a pair of 6S4 triodes for drive and phase splitting and then to the four output tubes. The 5654 is triode-connected, which drops its plate resistance from 200 kohm to 10 kohm, and it supplies most of the gain. The 6S4 replaced the triode-strapped E282F pentode of the MK2. It has a plate resistance of 3.7 kohm, a mu of 16, a transconductance of 4.5 mA/V and a plate dissipation of 7.5 W. Company head Kang Su Park describes it as a rare tube with good characteristics. The output and power transformers use nickel Permalloy cores and grew in size for this version, and Allnic states that the power transformers keep voltage fluctuation extremely low. Outside, the casework is larger, and the power switch moved from the right side to a push button on the front panel, where the pentode and triode modes are also selected.
Pairing
The two operating modes let one pair of monoblocks serve different loudspeakers - pentode mode for larger, harder-to-drive designs and triode mode where less power is needed. A balanced preamplifier can use the XLR inputs, and the modest damping factor is worth keeping in mind with speakers whose impedance swings widely.
Alternatives
For more power, Allnic offers the M-10000 Signature monoblock, fitted with eight KT170 tubes per chassis and up to 500 W of output.