The Allnic Audio A-5000 DHT, a single-ended tube monoblock, comes from the South Korean maker led by designer Kang Su Park, and every tube in its signal path is a directly heated triode. A Marconi HL-2 from new old stock handles the input, an STC 3A110A or an equivalent type works as the driver, and a single 300B forms the output stage. The supply is tube rectified, with a 5U4G fitted, and a pair listed at USD 19,900 in the US.
Key specs that matter
Each chassis delivers 10 W of class A power into 8 ohm, with speaker taps for 8 and 16 ohm loads. Voltage gain is 24 dB, and full rated output needs about 0.6 V of input signal. The input impedance of 100 kohm comes with a frequency range that runs from 20 Hz to 20 kHz, while distortion is rated at 0.5 percent at 1 kHz into 8 ohm at 2.83 V. The damping factor is 4.7 at 1 kHz. A single chassis is 435 mm wide, 245 mm high and 320 mm deep, with a weight of 20 kg.
Engineering and use context
The 3A110A driver is loaded by a plate choke with a core of pure Permalloy, and Allnic picked this inductor load for its low losses and very high impedance when swinging the 300B grid. The output transformer uses a large nickel Permalloy core of mixed ratio, sized to stay out of magnetic saturation at a current of 200 mA, which lets the primary have fewer turns while keeping open-circuit inductance high. The 300B runs with fixed bias instead of self bias, so no cathode resistors are needed and their heat is gone. About 6 dB of global negative feedback is applied, more than many 300B single-ended designs use, and the aim is a higher damping factor and lower distortion. Construction is point-to-point hard wiring with no circuit boards. An analogue meter monitors output tube current, the bias controls sit within easy reach, and plate voltage arrives only once the soft-start circuit has completed the heating period. XLR and RCA inputs are both provided.
Pairing
With low power and a modest damping factor, the A-5000 DHT belongs with high-sensitivity speakers whose impedance curve stays smooth, such as horns or wide-band designs. Older loudspeakers and other high-impedance designs connect to the 16 ohm tap. A tube line stage such as the Allnic L-9000, or a DAC with variable output, can feed it directly. Allnic also builds the D-5000 DHT converter, which shares the directly heated triode approach of the 5000 series.
Alternatives
For more power from the same maker, the Allnic M-2500 is a push-pull monoblock offered with PX25, 300B or KT150 output tubes.