The Allnic Audio M-2500 is a push-pull tube monoblock from the South Korean company of designer Kang Su Park, and the buyer picks one of three output tube types when ordering. The PX25 and 300B versions run their output tubes as triodes, while the KT150 version operates in pentode mode for far more power. US list prices were USD 15,500 per pair for the PX25 model, USD 14,900 for the 300B and USD 14,500 for the KT150. Both silver and black fascias are offered.
Key specs that matter
Continuous output is 20 W with PX25 tubes, 30 W with 300B and 100 W with KT150. Voltage gain is 26 dB, the single-ended input presents 100 kohm, and the KT150 version reaches full power from 0.7 V. The frequency range extends from 20 Hz to 50 kHz, distortion stays below 0.01 percent at 1 kHz. Noise sits 100 dB below the signal (CCIR, 1 kHz). Every monoblock is 440 mm wide, 260 mm high and 370 mm deep and weighs 20 kg.
Engineering and use context
The driver section changes with the output tube. In the 300B version a 6485 pentode wired as a triode handles the input and a pair of 12A4 tubes drives the output stage, whereas the PX25 and KT150 versions use a 5654 input tube and a pair of 6S4 drivers. Rectification comes from a directly heated 5U4G instead of semiconductor diodes, and its chimney acts as a Faraday cage. The output transformers have 114 mm cores of nickel mixed with FeSi. Allnic calls them Full Engagement transformers because all four secondary windings stay connected at every setting, which the maker says prevents parasitic oscillation in unused windings. A rear toggle selects the load setting, either 4 and 8 ohm or 8 and 16 ohm depending on factory configuration. A switchable analogue meter reads the current of each output tube, with a bias control beside each tube, and a soft-start circuit feeds plate voltage only after warm-up. The enclosure is assembled from four aluminium pieces rather than the six-piece chassis of most Allnic models, which lowers its cost.
Pairing
The triode versions suit efficient speakers with an even impedance curve. The KT150 model has enough reserve for speakers of average sensitivity in larger rooms. Because of the 26 dB gain, any tube or transistor line preamplifier with normal output level will drive the amplifier fully, and Allnic offers its own L-series line stages for an all-Allnic chain. Each monoblock needs open space above the tubes for ventilation.
Alternatives
For single-ended operation from the same maker, the Allnic A-5000 DHT monoblock uses one 300B with directly heated triodes throughout.