The A311m PX25 is the PX25 version of the Allnic Audio A-311M, a single-ended tube monoblock made in South Korea. The owner chooses the directly heated output triode when ordering, and in this version the interstage and output transformers are wound for the PX25 alone, so a finished amplifier cannot later be converted to a 300B or an AD1. The stock output tube is the PX25 currently made by KR Audio in the Czech Republic, and new PX25 tubes also come from TJ Full Music in China. Original PX25 tubes were made in the past under the Osram, GEC, Marconi and Cunningham names.
Key specs that matter
In PX25 form each monoblock gives 6 W into 8 ohm, all of it in Class A. Voltage gain is 24 dB, the noise floor is 76 dB down, and response stays within 1 dB from 20 Hz to 20 kHz. The chassis is 380 mm wide, 190 mm high and 280 mm deep. Speaker taps come as an 8 and 4 ohm pair or a 16 and 8 ohm pair, fixed when the amplifier is ordered. A pair was priced at USD 13,900 in 2018.
Engineering and use context
The first A-311M used three stages, with a 5654 input tube, an E182CC driver and manual bias. Allnic later cut the circuit to two stages. An E810F pentode strapped as a triode now supplies all the voltage gain and drives the PX25 through an interstage transformer, and the amplifier uses no global or local negative feedback. Bias of the output triode is now automatic, and there are no bias controls for the owner to set. A 5U4G type rectifier feeds the high-voltage supply, and Allnic also evaluated a Chinese military 5Z3PG for this socket. The analogue current meter doubles as a fault indicator - a needle pinned to the left shows a failed output tube, and one pinned to the right shows a rectifier problem. Soft-start circuitry shields the tubes from stress each time the amplifier is turned on. The output transformer uses a nickel and iron core, which lets Allnic reach high inductance with fewer turns, and all secondary windings stay connected whichever tap the speaker cable uses. A switchable XLR input sits next to the standard one for convenience, yet the signal path remains single-ended from input to output.
Pairing
Since each chassis delivers only single-digit power, the PX25 version suits horn loudspeakers and other high-efficiency designs whose impedance stays close to the tap ordered. With moderate voltage gain, it needs a line preamplifier with healthy output, such as a tube line stage. Because the PX25 is still in production at two factories, replacement output tubes remain available.
Alternatives
The Allnic Audio M-2500 is another monoblock that can also be ordered with PX25 output tubes, rated at 20 W in that form.