The Allnic Audio A-10000 DHT is a tube monoblock that delivers 100 W from a single-ended triode output stage in Class A. Instead of one large output tube, each chassis runs two Kron 1610 directly heated triodes in parallel. Its public debut came at the 2014 Munich High End exhibition, when a pair was priced at USD 89,000.
Key specs that matter
A drive of 1.4 V at the input brings the amplifier to full output, which corresponds to a voltage gain of 26 dB. Owners can connect the source through either a balanced XLR or a single-ended input, and both present 100 kOhm. The frequency range runs from 20 Hz to 20 kHz, total harmonic distortion reaches 0.2%, and noise sits 78 dB down. Each monoblock measures 440 x 540 x 460 mm and weighs 45 kg, so a pair needs two sturdy floor platforms rather than a rack shelf.
Engineering and use context
An HL-2 directly heated triode handles the first stage, and a custom KR242 triode, a tube Allnic developed for its own range, drives the paralleled 1610 pair. The output transformers are wound on mixed nickel permalloy cores, and their windings follow the Full Engagement principle, in which every secondary section is driven at all times and no tap is left idle. Bias current for the output tubes is easy to adjust, and an analogue meter on the chassis shows the current through the power tubes. The chassis itself is low and almost square, while the two big triodes stand under clear protective column cages that rise well above the top plate. Each 1610 is about the size of a bottle, and the pair of cages gives the amplifier its tall profile despite the flat main body. A stereo system therefore runs four 1610 output tubes across its two chassis, plus one KR242 and one HL-2 in each.
Pairing
With its power rating, the A-10000 DHT is not limited to horn speakers and can drive conventional box speakers of moderate sensitivity. Output taps for 4 ohm and 8 ohm loads allow the owner to choose the winding that fits the nominal impedance of the speakers. A tube preamplifier with modest output current has no trouble driving its inputs, and the balanced input suits a preamp with XLR outputs over a longer cable run. Two heavy chassis with large heated triodes give off considerable heat, so each one needs free air above its tube cages and a mains outlet within easy reach of its own platform.
Alternatives
The Allnic Audio A-5000 DHT is a lower-powered SET monoblock in the catalogue, using a single 300B per chassis.