Fyne Audio

In the Fine Audio F1-5 model, the midrange woofer has a diameter of 5 inches, and the tweeter located deep in the mouth is equipped with a magnesium alloy dome with a diameter of 19 mm.

In Fine Audio F1-8, the corresponding drivers sizes are 8 inches and 25 mm. The bass diffusers are mounted on suspensions with the proprietary FyneFlute profile, the baskets are made of cast aluminum, and the magnets are made of ferrite.

In Fine Audio F1-8, the corresponding drivers sizes are 8 inches and 25 mm. The bass diffusers are mounted on suspensions with the proprietary FyneFlute profile, the baskets are made of cast aluminum, and the magnets are made of ferrite.

Acoustic systems are versatile in use: they can be used on racks, on furniture shelves, on a wall bracket, as well as as stereo or front or rear channels of a home theater.

Two–way systems are designed according to the classical phase-reversal scheme with the port output backwards (so that the speaker cannot be installed close to the walls, it is necessary to step back 40-50 cm). The input power can reach 100 watts, the speakers themselves will "start up" from 25 Watts – the resistance is stated at 8 ohms, the sensitivity is 89 dB, the load is not complicated.

A distinctive feature is the use of a Tractrix diffuser, thanks to which the woofers spread evenly throughout the room. This allows you to install the device in any part of the room without the risk of reducing the fidelity of playback. The audio frequency separation filter includes induction coils with multilayer cores and polypropylene capacitors.

A 15-cm midrange/woofer IsoFlare driver is installed inside. The diffuser uses a FyneFlute roller suspension for better heat dissipation. The die-cast aluminum housing housing the diffuser contains a magnet that focuses the flow to increase efficiency at low frequencies. The 2.5cm tweeter with waveguide is borrowed from the F700 model.

Fyne Audio F5E — bookshelf speakers from the F500E series of budget acoustics. They feature a 5-inch IsoFlare driver and an ambient FyneFlute driver for accurate stereo imaging and detailed sound.

The F700 bookshelf speaker is equipped with a 150mm IsoFlare point source driver with a BassTrax LF diffuser. The bass driver loads the lower port of the bass reflex.

The Fyne Audio F701 is a bookshelf two-way speaker designed for home use. The Bass trans Port System bass reflex port is built into the bottom of the cabinet. The crossover separation filter includes silver-plated Van den Hul conductors, inductors with minimal losses and Claritycap capacitors.

The model has an IsoFlare emitter, which combines a 20-centimeter bass/midrange driver with a compression tweeter with a 2.5 cm diameter dome made of magnesium.

Using a 200mm (8”) vintage classic IsoFlare with FyneFlute roll surround sound and a proven 25mm magnesium dome compression tweeter, this luxurious retro design integrates a smaller form factor BassTrax transfer system, delivering phenomenal bass from a relatively compact body. Decorated with a vintage classic woven fabric grille, the Fine Audio Vintage Classic VIII will easily fit into any room.

The elegant streamlined body of the Vintage Five is only 35 cm high, with modern proportions and rounded corners, it has a unique retro fleur of the 60s of the last century, accentuated by the tweed pattern of the protective and decorative mesh fabric. This grid hides only one small speaker with a diameter of 125 mm, but which contains two drivers: a regular woofer/The MF and the dome HF hidden in its magnetic system.

The main feature of the Fyne Audio F1-10 as a source of sound waves is the point nature of sound emission. The entire spectrum of sound frequencies is radiated from a single point, which meets all acoustic requirements for coherence, phase accuracy and delay of the musical signal.

The model has the most powerful IsoFlare driver ever made by Fine Audio: a 300mm woofer/midrange diffuser and a 75mm treble dome.

In the new Fyne Audio F1-8S speaker, the mounting of the IsoFlare coaxial driver has been improved, and the crossover circuit has been changed to take into account the operation of the radiators in a larger housing. The IsoFlare coaxial driver works almost as a point source of sound – an ideal option in terms of the phase consistency of the radiators.

Fyne Audio F302i is a transition to a new floor format made by Fyne engineers based on the shelf model F301. By increasing the volume of the case and fine-tuning the bass reflex, the overload capacity is increased, the depth of the bass and the dynamics of the sound are expanded, both at low and high volume levels.

The Fine Audio F303i occupies the top position in the F300 line and will provide the most extensive dynamics, openness and purity of sound. Powerful rich sound from a two-way speaker with two 150mm woofer/midrange drivers and a 25mm dome treble driver.

The IsoFlare coaxial design developed by Fine Audio implements a point sound source with isotropic sound field energy and uniform directivity. Thanks to it, a three-dimensional stereo panorama with a clear localization of sound sources is achieved.

The Fyne Audio F501E is a floorstanding loudspeaker from the F500E series of budget speakers. She received an Isoflare driver equipped with a proprietary Fine multi-fiber diffuser with a FyneFlute suspension and a titanium dome tweeter with a powerful neodymium magnetic system.

The speaker housings are supported by an aluminum base, the purpose of which is to increase the stability of the structure and ensure efficient operation of the BassTrax Tractrix phase inverter port, pointing downwards. The manufacturer declares the lower limit of the operating range at 36 Hz for the Fyne Audio F501SP. The acoustic sensitivity is 91 dB.

The Fyne Audio F502 universal speakers are capable of rocking a large room, but they also work well at low volume levels or in small rooms. Thanks to the isotropic radiation of sound from a point source (200 mm IsoFlare woofer/treble speaker), even in difficult acoustic conditions, a three-dimensional stereo picture is provided, even if the listener is not sitting in the center.

The F502SP drivers set generally repeats the model of the older series (F702): a 200 mm coaxial IsoFlare with a FyneFlute suspension (variable pitch corrugation) and a 25 mm magnesium alloy dome loaded on a divider that equalizes the phase of RF radiation.

The main IsoFlare coaxial driver of this model has a diameter of 200 mm, high-quality induction coils, Claritycap capacitors, and van den Hul wiring are used in the separation filter.

The Fyne Audio F702SP floorstanding speaker features increased performance and improved sound quality compared to the F700 model released in 2018.

Fyne Audio F703 is a floorstanding speaker based on two 250mm drivers of its own design, an IsoFlare midrange/treble speaker and a woofer. Both drivers are loaded with a unique woofer design with a Bestrex divider and operate in a so-called 2.5-band configuration.

The 250 mm MF/HF Insulated driver is used here. It is unique in that the magnetic circuits of both radiators use rare earth magnets. Neodymium-based magnets have a much higher magnetic induction, which allowed Fyne Audio engineers to significantly reduce distortion, increase speaker overload capacity and achieve a wide operating frequency band with a very high sensitivity of 94 dB.

The Fyne Audio 704 is equipped with serious-sized drivers with composite diffusers of 300 mm each! The first one is responsible for the midrange and treble, it is designed according to the IsoFlare point source scheme, the second one works on bass.

The Fyne Audio Vintage Classic Gold VIII SP is a two—way floorstanding speaker with a bass reflex. This is the youngest model of the line, but it has impressive dimensions: 873 x 380 x 300 mm.

The Fyne Audio Vintage Classic Gold VIII SP is a two—way floorstanding speaker with a bass reflex. This is the youngest model of the line, but it has impressive dimensions: 873 x 380 x 300 mm.

The Fyne Audio Vintage Classic Gold XII SP is a floorstanding loudspeaker from the Vintage Classic Gold SP series. It is equipped with a compression tweeter with a titanium dome with a diameter of 75 mm and a neodymium magnetic system.

Fyne Audio Vintage Classic Gold XV SP is the top model of the Vintage Classic Gold SP line of acoustic systems. It is equipped with an IsoFlare coaxial driver with a paper-fiber diffuser with a diameter of 380 mm and a 75 mm compression tweeter with a titanium dome and a neodymium magnetic system.

The Classic VIII is smaller in size than other Classic series floorstanding speakers (XII and X) and can be used in relatively small spaces. The manufacturer recommends the distance between the right and left speakers in the range from 1.5 to 4.5 meters.

If you remove the tweed fabric safety net (also a sign of retro), then we will see only one driver on the front panel of the Classic X. This is an absolute advantage of Fyne Audio's proprietary technical solution, the IsoFlare coaxial woofer/RF emitter (details below). Another interesting decoration of the front panel is the smooth controls of the amplitude—frequency response in the midrange and treble areas (they are also described below).

The design feature of the Classic XII case is two internal sections of the phase reflex system. The first section is a conventional 4th-order resonator connected to the main body through a tube, but its outlet is loaded onto a special 360-degree divider in the lower section, which evenly distributes the wave front in all directions through the bottom of the speaker body.

The flagship of the classic Vintage Fifteen series takes 100% advantage of the new IsoFlare coaxial driver with a diameter of 380 mm (15 inches), and there are many such advantages.

The Fyne Audio Vintage Ten is a classic "warm" design with a touch of retro, an elegant body with modern proportions and high—resolution sound. A small-sized outdoor home monitor for a wide variety of rooms, any musical genres, universal for transistor and tube amplifiers.

Fyne Audio Vintage Twelve is a 2–way monitor-type floorstanding speaker with a downward-pointing bass reflex in a classic style

A built-in 475-watt Direct Digital (DDX) digital amplifier and a 250-millimeter driver are installed in a moderate-sized case, and a powerful digital DSP sound processor allows for effective overload protection, adaptive dynamics, and Bass Boost mode for low-frequency home theater effects.

The F3 series of subwoofers is led by the F3-12 model, an advanced achievement of Fyne Audio. It uses a 300-millimeter long-stroke woofer, a DDX digital amplifier with a power of more than half a kilowatt, and a digital DSP processor that perfectly accounts for the coupling of speaker and amplifier parameters, which implements Bass Boost protection, filtering, and boost circuits for a greater depth of effects in a home theater.

The F3 series of subwoofers is led by the F3-12 model, an advanced achievement of Fyne Audio. It uses a 300-millimeter long-stroke woofer, a DDX digital amplifier with a power of more than half a kilowatt, and a digital DSP processor that perfectly accounts for the coupling of speaker and amplifier parameters, which implements Bass Boost protection, filtering, and boost circuits for a greater depth of effects in a home theater.

With a body volume of only 26 liters, the F3-8 delivers real deep bass with a record-breaking 35 Hz cutoff frequency for this price group.