The Trim T10 is the smallest floorstanding loudspeaker of Bryston's T10 series, a three-way tower placed below the Middle T10 and the Model T10. Like the other T10 towers, it is a partial line array, and Bryston states that its sound radiates outward in an expanding cylinder rather than in a sphere. It is constructed in Canada and covered by a 20-year warranty to the original owner.
Key specs that matter
Enclosure type is Reflex / Vortex. Two 25 mm titanium tweeters, two 133 mm midrange drivers and two HP 165 mm woofers make up the driver complement, crossed over at 250 Hz and 2 kHz. Frequency response is 32 Hz - 20 kHz (±3 dB), and nominal impedance is 4 ohms. Sensitivity is 91 dB in room and 87 dB anechoic (1 W/1 m). Minimum amplifier power is 30 W, and maximum is 700 W RMS. Dimensions are 1520 x 260 x 410 mm (H x W x D), with a weight of 38 kg each.
Engineering and use context
Each driver type is doubled, and Bryston uses these units in parallel so that the system plays louder with less effort. Bryston specifies a flat response from ±15 degrees off axis. Its passive crossover network splits the spectrum and corrects small non-linearities of the drive units. Thick cabinet walls are combined with a front baffle up to 38 mm thick and a network of internal braces. The vent has a fluted port profile, developed to eliminate vent noise and the turbulent distortion often associated with ports.
Four changeable modules are supplied with every speaker - single-amp, bi-amp, tri-amp and active. Swapping the passive crossover module for the active one converts the speaker to active operation. In that case no internal crossover is present, and the high-frequency, midrange and low-frequency sections are each powered by a separate amplifier channel. The BAX-1 DSP crossover receives a line-level analogue signal, converts it to digital at 96/24, divides the bands and corrects the response. Its settings are factory programmed for each T10 model, it is controlled through a web-based user interface, and its firmware is upgradeable.
Walnut, Boston Cherry and Black Ash are the in-stock veneers.
Pairing
An amplifier stable into 4 ohms is required. In active mode a pair needs the BAX-1 and six amplifier channels. The matching subwoofer is the Trim TS-10 Sub Tower with four 165 mm drivers and the BAX-2 crossover.
Alternatives
The Bryston Middle T10 is the next tower up, with four HP 165 mm woofers and a 28 Hz lower limit.