Hifiverse

Floorstanding loudspeakers - Bryston MIDDLE T10

Description, images, technical data and specifications

Bryston MIDDLE T10
Image source - (c) Bryston

The Middle T10 is a three-way floorstanding loudspeaker in Bryston's T10 series, positioned between the Trim T10 and the Model T10. Bryston describes its tower speakers as partial line arrays, which radiate sound outward in an expanding cylinder, as though from a line in space. Each loudspeaker is constructed in Canada and carries a 20-year warranty to the original owner.

Key specs that matter

Enclosure type is Reflex / Vortex. The driver complement consists of dual 25 mm titanium tweeters, dual 133 mm midrange drivers and four HP 165 mm woofers, with crossover points at 250 Hz and 2 kHz. Frequency response is 28 Hz - 20 kHz (±3 dB). Sensitivity is 92 dB in room and 88 dB anechoic (1 W/1 m), and nominal impedance is 4 ohms. Bryston specifies a minimum amplifier power of 50 W and a maximum of 1000 W RMS. Dimensions are 1702 x 254 x 432 mm (H x W x D), and each speaker weighs 46 kg.

Engineering and use context

Bryston uses multiple drive units in parallel for higher output than a single driver solution. Its internal crossover network divides the spectrum between the drivers and is also used to correct small non-linearities in the drive units. Bryston developed the drivers with modelling and finite element analysis tools and verified them in its own anechoic chamber and accelerated life test facility. Inside the cabinet, thick walls and a front baffle up to 38 mm thick are tied together by a network of internal braces. According to Bryston, the fluted port profile eliminates vent noise even at high pressures.

Every speaker comes with four changeable modules - single-amp, bi-amp, tri-amp and active. A passive Middle T10 becomes an active one when the passive crossover module is exchanged for the active module. In active form no internal crossover is present, and each driver section is powered directly from its own amplifier channel. That mode uses the BAX-1 DSP crossover, which has an XLR analogue input, 96/24 conversion and three pairs of XLR outputs for low, mid and high. Its factory-programmed software is dedicated to this model and is based on more than 300 measurements in Bryston's anechoic chamber.

In-stock finishes are Walnut, Boston Cherry and Black Ash, and other natural wood and painted veneers can be ordered.

Pairing

An amplifier stable into 4 ohms is required. Active operation requires the BAX-1 and three amplifier channels of equal gain per speaker. The matching subwoofer is the Middle TS-10 Sub Tower with six 165 mm drivers, used with the BAX-2 crossover.

Alternatives

The Bryston Model T10 is the larger tower of the series, with four 203 mm woofers and a 25 Hz lower limit.

Specifications

More components