Hifiverse

Floorstanding loudspeakers — Bryston Model T

Description, images, technical data and specifications

Bryston Model T
Image source - (c) Bryston

The Model T is a three-way floorstanding loudspeaker from Bryston of Canada and the largest model of its Model T range. It started in 2010 as a personal R&D project of Bryston vice president James Tanner, who worked with outside loudspeaker engineers for two years before the first pair was built for his reference system. Two versions exist - the Model T Passive with a built-in crossover and the Model T Signature with the outboard Signature Edition crossover. All Bryston loudspeakers are manufactured in Canada and are covered by a 20-year warranty against defects in materials or workmanship.

Key specs that matter

Each cabinet carries seven drive units - three 8-inch bass drivers, two midranges and two titanium dome tweeters. Midrange and bass diaphragms are anodised aluminium. Frequency response is 25 Hz - 20 kHz (±3 dB), and sensitivity is 89 dB (2.83 V, 1 m, anechoic). Nominal impedance is 4 ohms. Bryston gives a minimum/maximum recommended power of 10 - 500 W RMS and a maximum SPL of 118 dB at 1 m. Connection is via dual 5-way binding posts. Dimensions are 1334 x 267 x 419 mm (H x W x D) without feet, and unpacked weight is 48.5 kg.

Engineering and use context

Bryston uses several drive units in parallel in each of the three sections so that the system plays louder with less effort than a single-driver design. The crossover networks divide the spectrum between the drivers and also correct small non-linearities of the driver elements. Drivers were developed with finite element analysis and then verified in Bryston's on-site anechoic chamber and accelerated life test facility.

All drivers are bolted to a 38 mm (1.5 in.) thick front baffle. Walls and internal braces are 19 mm (0.75 in.) thick. Boston Cherry, Black Ash and Walnut are standard finishes, with other veneers on request. Black fabric grilles, padded furniture feet, carpet spikes and a binding post wrench are included. Optional outriggers with larger spikes increase stability.

Pairing

An amplifier rated for 4 ohm loads is required. Its dual binding posts allow bi-wiring or passive bi-amping. The matching centre channel is the TC1, which uses the same drivers, and the matching subwoofer is the Model T Sub.

Alternatives

The Middle T is the smaller floorstanding model of the same range, with two 8-inch bass drivers, one midrange and one tweeter.

Specifications

More components