The Project K2 S9900 is a three-way floorstanding loudspeaker from JBL with one 380 mm woofer and two horn-loaded compression drivers. It belongs to the JBL Project loudspeakers, the line of the Hartsfield and Paragon, and its enclosure recalls both the Project Everest DD66000 and the K2 S9800. JBL calls the configuration an augmented two-way. The S9900 dates from 2009, and finishes are Rosewood plus a selection of high-gloss automotive-grade paints.
Key specs that matter
Bass comes from the 1500AL-1 pulp-cone woofer, the main band from the 476Mg compression driver with a 100 mm magnesium-alloy diaphragm, and the top octaves from the 045Be-1 ultrahigh-frequency driver with a 25 mm pure-beryllium diaphragm. Crossover frequencies are 900 Hz (24 dB/octave) and 15 kHz (24 dB/octave, high-pass only). Frequency response is 48 Hz - 50 kHz (-6 dB), with low-frequency extension to 33 Hz (-10 dB). Sensitivity is 93 dB (2.83 V/1 m). Nominal impedance is 8 ohms, with minimums of 7 ohms at 100 Hz and 4 ohms at 40 kHz. HF coverage is 100 x 60 degrees and UHF coverage 60 x 30 degrees. Each cabinet measures 560 x 1200 x 350 mm (W x H x D) plus 20 mm for feet and weighs 82.7 kg.
Engineering and use context
Above 900 Hz the 476Mg and its horn work unassisted to 20 kHz, and the 045Be-1 adds two octaves of ultrasonic range. In the 1500AL-1 a 100 mm voice coil sits in a radial field from an alnico 5DG magnet, with a shorting ring, a top plate of copper-steel laminations and Vented Gap Cooling. Coil length grew to 25.4 mm from 20.3 mm, and JBL rates the driver for up to 25 percent more power than the 1500AL. Its layered paper-pulp cone has Aquaplas damping, an EPDM foamed rubber surround and dual inverted Nomex spiders.
At 130 microns, the magnesium-alloy diaphragm of the 476Mg is 2.5 times thicker than the titanium diaphragm of the original K2 S9500, at about 3.4 g. The 045Be-1 diaphragm is under 0.04 mm thick and weighs 0.1 g. Its Bi-Radial horn holds 60 x 30 degrees from 10 kHz to 50 kHz. A curved baffle forms the sidewalls of the main horn, with SonoGlass lips top and bottom. The enclosure is 25 mm MDF, and one 100 mm flared rear port is tuned to 35 Hz. Air-core inductors and polypropylene foil capacitors are used, and a 9 V battery biases the capacitors. Rear switches trim the HF level by about 0.5 dB over 1 kHz - 15 kHz and the 1.5 - 3 kHz region by about 0.3 dB.
Pairing
An amplifier of at least 100 W is required for full-range use, and JBL names 100 - 500 W with very high current capacity as optimal. Separate LF and HF rear input terminals allow bi-wiring. JBL does not advise active bi-amplification.
Alternatives
The JBL Project Everest DD67000 is a larger floorstanding Project model with two 380 mm woofers and beryllium compression drivers.