Hifiverse

Floorstanding loudspeakers - Gauder Akustik ELARGO 200

Description, images, technical data and specifications

Gauder Akustik ELARGO 200
Image source - (c) Gauder Akustik

The ELARGO 200 is the larger of the two floorstanding loudspeakers in the Elargo series of Gauder Akustik, the loudspeaker maker from Renningen near Stuttgart. Introduced in 2024, the series also includes the smaller ELARGO 100 and the Elargo Center. Finishes are piano lacquer black, piano lacquer white and rosewood high gloss.

Key specs that matter

Design is a 3-way bass-reflex floorstanding speaker. Two 22 cm XPulse long-throw bass units have stiffened aluminium cones and rear-ventilated centring spiders. An XPulse midrange driver with a lightweight, damped aluminium cone sits in a closed midrange enclosure. The tweeter has a beryllium dome and an iron-neodymium-boron magnet. Crossover slopes are steeper than 50 dB per octave. Nominal impedance is 4 ohms. Dimensions are 126 x 30 x 43 cm (H x W x D), and weight is 50 kg.

Engineering and use context

Its drop-shaped cabinet consists of several layers, is heavily braced inside and uses Gauder's highly damped insulation material in the closed midrange/treble enclosure. The bass-reflex section is downward-ventilated, with the bass radiating towards the floor. Gauder describes the crossover as symmetrical, with the negative pole of each driver decoupled from the system ground by crossover components, and states that this reduces feedback to the amplifier. TDC Time Delay Control is a circuit in the crossover that electrically delays the tweeter signal so that it matches the delay the inductors introduce in the lower-frequency path. According to Gauder, its speakers cross over from bass to midrange between 120 Hz and 166 Hz. Crossover parts come exclusively from Mundorf, IT and WBT, and the internal wiring is Clearwater cable.

On the back, the terminal panel carries four WBT NextGen binding posts for bi-wiring or bi-amping, a three-stage bass level control (-1.5 dB, linear, +1.5 dB) and two sockets of the Bass Extension System for a bridge or modules. A large base with four geared adjustment knobs and a height scale sets the angle of inclination, and four shims are included. The beryllium tweeter can be replaced by the diamond version at any time without changing the crossover, and a front grille with magnetic holder is optional.

Pairing

An amplifier rated for a 4 ohm load is required. The WBT terminals allow bi-wiring or bi-amping. For home theatre, the matching centre speaker is the Elargo Center.

Alternatives

The ELARGO 100 is the smaller model of the series, with two 7 in bass drivers and a height of 119 cm.

Specifications

More components