The SCM12i Pro is the installation variant of the SCM12 Pro, a compact passive two-way nearfield monitor in the professional range of ATC. It is intended for fixed installation in recording, post-production, broadcast and film studios, including surround and multichannel mixing rooms and Dolby Atmos, DTS:X and Auro 3D rooms. Acoustically both versions are identical, and the i model adds fixing hardware and weight.
Key specs that matter
Its tweeter is the SH25-76, a 25 mm soft dome with dual suspension, rated at 6 ohms. Below the 2.2 kHz crossover point a 150 mm bass/mid driver with Constrained Layer Damping (CLD) takes over. Amplitude linearity is ±2 dB from 80 Hz to 16 kHz, with -6 dB points of 56 Hz and 22 kHz (free standing). A pair reaches 108 dB SPL continuous at 1 m. Coherent dispersion is ±80° horizontal and ±10° vertical. Nominal impedance is 8 ohms, and ATC recommends amplifiers of 75 - 300 W. Each cabinet measures 400 x 238 x 235 mm (H x W x D) and weighs 15 kg, against 11 kg for the standard SCM12 Pro.
Engineering and use context
ATC applies CLD to the bass/mid cone to lower harmonic distortion in the midrange and to improve magnitude linearity and off-axis behaviour. Its voice coil is hand-wound from edge-wound flat OFHC copper ribbon, and the motor system is vented front and rear to lower airflow noise. In the tweeter the second suspension suppresses rocking modes of the diaphragm, and no ferrofluid is used in the gap.
The passive crossover connects to a bi-wire panel, with the upper terminal pair for the tweeter, the lower pair for the woofer and removable links for single-cable use. On the rear of the cabinet are four M8 threaded points in the standard 69.9 x 127 mm pattern, supplied with M8 x 30 button head screws, and an M8 eyebolt at the top rear corner for a safety point.
Pairing
ATC specifies an amplifier able to supply more than 150 W continuous into the rated load. The matching ATC amplifier is the P1 Pro, rated at 150 W per channel. Speaker cable of at least 2.5 mm2 per conductor is specified.
Alternatives
The ATC SCM12 Pro is the freestanding version of the same passive two-way monitor, without the fixing hardware.