Mission's LX-3 MKII is a two-way standmount loudspeaker and the largest of the three standmount models in the LX MKII Series, above the LX-1 MKII and LX-2 MKII. The nine-model series also includes three floorstanding speakers, two centre speakers and the LX-3D Surround MKII, and it sits below the mid-level QX and flagship ZX ranges. Mission lists it for stereo and for surround use. In Australia a pair was priced at AUD 849.99. Walnut Pearl, Lux White and Lux Black are the finishes, the last two matte.
Key specs that matter
A 165 mm composite fibre bass driver and a 25 mm microfibre dome treble driver are used in a bass reflex enclosure, with the crossover at 3.2 kHz. Sensitivity is 88 dB (2.83 V/1 m), and peak SPL is 105 dB. Nominal impedance is 8 ohms compatible, with a 4.1 ohm minimum. Frequency response is 45 Hz - 20 kHz (±3 dB), with bass extension to 40 Hz (-6 dB). Recommended amplifier power is 20 - 120 W. Cabinet volume is 13.2 litres. Height on the plinth is 345 mm, width 226 mm and depth 300 + 8 mm with terminals. Net weight is 8.42 kg per speaker. The cabinet is not magnetically shielded.
Engineering and use context
Like other Mission models, the LX-3 MKII uses Inverted Driver Geometry (IDG), with the high-frequency unit placed below the bass/midrange driver. Mission says the path length is equalised so the sound waves coincide at the listener's head height and credits this with better time alignment and transient performance.
Peter Comeau, Mission's lead acoustic designer, refined the series over hundreds of hours of listening and used trickle-down innovations from the ZX range. Improvements in the DiaDrive bass unit give better control of the low-frequency diaphragm. Both drivers now have serrated surrounds, a detail taken from the ZX and QX development, to scatter interfering reflections from localised surfaces to the dome and cone and to smooth the frequency response. Each LX MKII crossover was then optimised for the revised drivers. Inside, the cabinet has a re-engineered bracing system.
Mission manufactures its drive units in its own factory with precision tooling. Terminals are single-wired binding posts. Foam bungs for the rear bass port are included to alter the bass parameters and damp resonances.
Pairing
An amplifier stable into 4 ohms is required. With a subwoofer, the AV processor speaker size is set to Small. The matching centre speaker is the LX-C2 MKII, and the matching subwoofer is the LX-10SUB MKII.
Alternatives
The LX-2 MKII is the smaller standmount of the same series, with a 130 mm composite fibre bass driver and a 305 mm tall cabinet.