The Mission 770 is a two-way standmount loudspeaker that brings back a model first introduced in 1978. Drawn up by Mission founder Farad Azima, the original became the brand's best-selling speaker and was followed by MK2 and MK3 versions. Its return was championed by Peter Comeau, Director of Acoustic Design at parent company IAG. It is made in the UK at Huntingdon, Cambridgeshire, where a production facility of about 836 m2 with a new anechoic chamber was added, for a total of about 2,323 m2 of office, lab and manufacturing space.
Key specs that matter
This 2-way vented-box design uses a 200 mm mineral loaded polypropylene cone and a 28 mm soft dome, crossed over at 2.9 kHz. Sensitivity is 88 dB (2.83 V/1 m), and peak SPL is 117 dB. Impedance is 8 ohms nominal, 6 ohms minimum. Frequency response is 42 Hz - 20 kHz (±3 dB), with bass extension to 30 Hz (-6 dB). Recommended amplifier power is 25 - 200 W. Cabinet volume is 38.5 litres. Each speaker is 590 mm high on its plinth, 300 mm wide and 300 + 22 mm deep with terminals, and weighs 19.2 kg.
Engineering and use context
Mission developed a new polypropylene mid/bass driver with a motor system upgraded for modern power handling. As on the original, it is built on a die-cast chassis with large rear windows to reduce early reflections back through the cone. A low-density nitrile surround matches the impedance of the cone and reduces reflections from its edge, and mineral loading makes the cone stiffer than the original. Cabinet and front reflex port are tuned to a very low frequency, and the port is strongly flared at inlet and outlet to smooth airflow.
Behind the damped microfibre dome sits a damped rear chamber that pushes the fundamental resonance well below the crossover region, and a high flux ferrite magnet is used. Over 170 crossover iterations were tried, with phase-corrected flat-delay acoustic slopes. The final circuit is laid out on separate bass and treble PCBs with very short signal paths, polypropylene capacitors and air core inductors, away from the drive unit magnets.
Where the original used a thin-wall cabinet damped by bitumen pads, the new one is a twin-wall sandwich of high-density MDF and particle board bonded by high-damping adhesive. Internal bracing strengthens the front baffle and braces the drive unit to the cabinet. Real-wood veneers are Walnut Pearl or Black Oak, with a white laminated front baffle.
Pairing
An amplifier rated for 8 ohm loads and within Mission's recommended power range is required. The matching stand is the Mission 770 Stand, hand made in England from British steel.
Alternatives
The Mission 700 is the smaller sister standmount, with a 165 mm mineral loaded polypropylene cone in a 24.8 litre cabinet.