Hifiverse

Phonovorstufen - Allnic Audio H-5500

Beschreibung, Bilder, technische Daten und Spezifikationen

Allnic Audio H-5500
Bildquelle - (c) Allnic Audio

The H-5500 is a tube phono preamplifier made in Korea by Allnic Audio, the firm Kang Su Park founded and designs for. It replaced the H-1202 as the entry model of the Allnic phono range and uses neither an LCR network nor directly heated triodes. Over the older model it adds a second moving coil input, Mu-metal shielding, a power supply with twice the capacity and a larger, heavier all-aluminium chassis.

Key specs that matter

Gain is +38 dB for moving magnet cartridges and +22, +26, +28 or +32 dB for moving coil types, all measured at 1 kHz. The MM inputs present 47 kOhm, while the MC inputs can be loaded at 278, 117, 69 or 29 ohm. Allnic gives a frequency response of 20 Hz to 20 kHz within 0.3 dB, RIAA accuracy within 0.3 dB, THD under 0.3% at 1 kHz and 1 V, with 68 dB (CCIR) for signal-to-noise. Output impedance is 1.2 kOhm. The MM input stays clear of clipping up to 30 mV at 20 Hz, 300 mV at 1 kHz and 500 mV at 10 kHz. The chassis measures 430 x 260 x 170 mm and weighs about 8.2 kg, and silver and black finishes are offered. A 2 A, 250 V fuse guards the mains inlet.

Engineering and use context

Four NOS E180CC twin triodes do the amplification, operating in pure Class A with no negative feedback loop. RIAA equalisation is handled by a CR network. A 7233 works as the voltage regulator and a 5654 as the voltage correction tube, so the supply is regulated by tubes throughout. Moving coil signals pass through step-up transformers with iron and nickel Permalloy cores of the type Allnic uses in the H-7000 and H-8000. Each step-up setting ties a load value to a fixed gain, and a pair of rotary pots on the top plate, one for each channel, choose the setting. These must be reset when switching between the two MC inputs. A backlit current meter on the front shows the state of the tubes, so a worn or failing tube is easy to spot. A soft start and a mute switch complete the controls, and the wider case fits a 19 inch equipment rack.

Pairing

Four RCA input pairs, a single RCA output pair and a ground terminal sit on the rear. Two MM and two MC inputs let one owner run a pair of turntables or a turntable with two arms without swapping cables. The single-ended RCA output feeds any tube or transistor line preamp with a standard input impedance.

Alternatives

The Allnic Audio H-6500 is another tube phono stage from the company, with its power supply housed in a separate chassis.

Spezifikationen

  • Modellbezeichnung

    H-5500

  • Eingänge (symmetrisch)

    N/A

  • Eingänge (unsymmetrisch)

    N/A

  • MC-Eingangsimpedanz (stromgekoppelt) (Ω)

    N/A

  • MM/MC-Eingangsimpedanz (spannungsgekoppelt) (Ω)

    47000 / up to 280

  • Ausgangsimpedanz (Ω)

    1200

  • Verstärkung (dB)

    MM +38dB (1kHz) / MC +22, +26, +28, +32dB (1kHz)

  • Genauigkeit der Wiedergabe-Entzerrungskurven (dB)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    20

  • Obere Grenzfrequenz +/- 3dB (Hz)

    20000

  • Klirrfaktor + Rauschen (%)

    0.3

  • Abmessungen (mm)

    N/A

  • Gewicht (kg)

    N/A

  • Offizieller Link