Allnic Audio of Korea calls the H-10000 OTL/OCL the head of its phono line. This vinyl preamplifier splits into an audio unit and a power supply, works without either transformers or capacitors at its outputs, and its dual-mono layout uses sixteen tubes, eight per channel, each under its own polycarbonate chimney. The US price is USD 45,000. Allnic states that from 2025 production 12B4 tubes take the place of the 7233 output tubes.
Key specs that matter
Two MM and two MC inputs, all on RCA, feed one RCA and one XLR output, and two screw terminals take the tonearm ground leads. Gain is 40 dB for MM, while built-in step-up transformers raise the MC figure to 62, 66, 68 or 72 dB. The MC load follows the transformer ratio automatically - 278, 117, 69 or 29 ohm. MM loading is 47 kOhm and output impedance is 50 ohm. RIAA response runs from 20 Hz to 20 kHz, distortion stays below 0.1% at 1 kHz and 1 V out, and noise sits 80 dB below signal (CCIR). The MM input accepts up to 300 mV at 1 kHz before clipping. The phono unit measures 430 x 380 x 200 mm and weighs 12.6 kg, the supply measures 430 x 330 x 130 mm and weighs 16 kg, and the pair draws 190 W from 110/120 V or 220 V mains.
Engineering and use context
Amplification happens in two stages with the passive equalisation network between them. Each stage uses an ECF802, an E180CC and a pair of 7233 triodes, with the second stage mounted in reverse order on the chassis. At the output, two 7233 tubes per channel form a single-ended push-pull circuit fed from positive and negative rails, which keeps DC away from the next component without a capacitor. The step-up transformers are wound with pure silver wire on high-permeability permalloy cores. Equalisation uses LCR modules with RIAA, Decca and Columbia curves, and turnover (250, 400, 500 or 700 Hz) and treble attenuation (-5, -11, -13.7 or -16 dB) are set separately for each channel from the front panel. Four meters, two per channel, show DC balance. The outboard supply uses solid-state rectification with automatic voltage regulation and has two separate circuits, one for each gain stage rather than one per channel, linked by umbilical cables.
Pairing
A low source impedance together with the balanced XLR socket makes long interconnects to a line stage practical, and the matching L-10000 OTL/OCL preamplifier follows the same output-transformerless approach. Four inputs let one owner run two tonearms or two turntables with MC and MM cartridges at once, and the adjustable curves suit mono and stereo pressings made before RIAA became the norm.
Alternatives
The Allnic H-8000 DHT is a two-chassis phono stage that uses direct-heated triodes and transformer coupling in place of the OTL/OCL output.