Shinjitsu Audio Hiro horn loudspeakers run straight from an Arcam A5 integrated amplifier, and that is the whole chain. This February 2025 home system leans on loudspeaker efficiency instead of amplifier size, so a slim British integrated with its own DAC and Bluetooth receiver is enough to feed a two-way horn design hand built to order in Arizona.
The system at a glance
Two components cover everything, with no separate source, preamplifier or outboard converter. The Hiro sells for USD 4,000 per pair. The pairing suits a listener in a medium-sized living room who wants a compact, mostly digital setup, with streaming over Bluetooth and an MM phono input left open for a turntable later.
Why these components work together
Shinjitsu rates the Hiro at 93 to 94 dB depending on the resistor fitted in the horn circuit, with an 8 ohm nominal load and support for amplifiers from 8 W upward. A Beyma CD171Fe/PK compression driver on a 12-inch ME45 constant-directivity horn covers the treble, while a Markaudio CHR 120 extended-range woofer handles everything below it, and the range is quoted as 40 Hz to 20 kHz. The Arcam A5 is a class AB design giving 50 W per channel into 8 ohm and 75 W into 4 ohm, so against a load this efficient it works far below its ceiling at normal levels. Its built-in ESS ES9018 converter accepts optical and coaxial inputs, and Bluetooth 5.2 with aptX Adaptive brings wireless streaming without another box. Three line inputs and the phono stage complete the analogue side. Because the horn module, driver and Continuum crossover sit outside the bass cabinet on their own plinth, the owner can retune horn level with the supplied resistors instead of changing amplifiers. Keeping the speaker to two drivers avoids splitting the midband across several crossover points.
How it sounds
With so little power needed, the amplifier stays in its cleanest operating range, and the compression driver gives transients a quick, direct start. Voices and small acoustic groups come forward with clear outlines, while bass from the single woofer is tight rather than room-filling, which fits small jazz and vocal recordings well.
Considering a similar setup
The key is efficiency. Any amplifier in place of the A5 only needs modest power, so build quality and noise floor matter more than wattage. Arcam's larger integrated models add power and inputs, and the Hiro horn resistor sets allow fine adjustment to the room before any electronics change.
The proprietary Mark Audio CHR 120 driver is installed in these speakers, which is paired with the compression Beyma CD171 FE/PK.
by Arcam
Arcam A5 integrated amplifier offers 2x 50 Watts of power into 8 Ohms load, Bluetooth 5.2 with AptX Adpative, and Hi-Res ESS ES9018 on-board DAC. Slim case and stunning design looks very impressive.