The SCM100ASLT is the active three-way floorstanding loudspeaker of ATC's Tower Series with a 314 mm bass driver and amplification inside the cabinet. In the name SL denotes Super Linear Magnet technology and A denotes built-in amplification. ATC also offers a passive version, the SCM100PSLT, for use with external amplifiers. Drive units and electronics come from ATC's own works in Gloucestershire. In the United States a pair has been priced from USD 30,000 to USD 39,000, depending on finish, and any veneer can be ordered.
Key specs that matter
Drivers are a 25 mm neodymium HF unit, the ATC SM75-150 S 75 mm soft dome midrange and the latest 314 mm SL-specification bass driver. A 350 W Class AB tri-amp pack supplies 200 W LF, 100 W Mid and 50 W HF. Frequency response is 65 Hz - 17 kHz (±2 dB) and 32 Hz - 22 kHz (±6 dB). Matched response is ±0.5 dB, and maximum SPL is 115 dB. Dispersion is ±80° horizontal and ±10° vertical, both coherent. Cabinet dimensions are 1070 x 397 x 560 mm (H x W x D), and each speaker weighs 68 kg.
Engineering and use context
Crossover points are 380 Hz and 3.5 kHz, with active 4th order Linkwitz-Riley filters ahead of the three amplifier channels. This built-in amplifier has frequency, gain and phase correction individually optimised at the ATC factory. Its bass driver uses a massive ATC motor assembly. Overload protection consists of active peak momentary gain reduction on all channels and an r.m.s. power limiter on the HF channel.
On the rear panel are the mains inlet, a power switch with indicator, a fuseholder and the XLR signal input. Input sensitivity is 1 V rms (0 dBV/1.1 dBu) balanced for full output, at 10 kohms per leg. Two screwdriver controls are provided - a sensitivity trim from 0 to -6 dB and a bass boost from 0 to +6 dB at 40 Hz, both continuously variable. As supplied, each monitor is calibrated to 1 V. ATC notes that adjusting either control without the ability to recalibrate leaves the two speakers of a pair no longer matched. Mains voltage is internally set to 100, 115 or 220 - 230 V (50/60 Hz). A 6-year warranty applies.
Pairing
A preamplifier, DAC or streamer with balanced variable line outputs is required. Unbalanced connection is possible, but ATC prefers balanced XLR-to-XLR cables. No external power amplifier is needed, and each speaker requires a mains cable and a signal cable.
Alternatives
The ATC SCM150ASLT is the larger active Tower Series model, with a 375 mm SL bass driver and 117 dB maximum SPL.