Hifiverse

Headphones - Audio-Technica ATH-AWAS

Description, images, technical data and specifications

Audio-Technica ATH-AWAS
Image source - (c) Audio-Technica

The ATH-AWAS is a closed dynamic headphone from Audio-Technica's line of wooden headphones, released in Japan on 15 November 2019. That line began in 1996 with the ATH-W10VTG, and over more than 20 years Audio-Technica has tried many woods suited to headphone housings. This model uses Asada Zakura, a traditional Japanese wood taken from trees more than 100 years old, with a refined red colour and a calm grain. According to Audio-Technica, the same wood is used in high-end loudspeakers for its acoustic properties and durability.

Key specs that matter

Type is closed dynamic with a 53 mm driver designed for this model. Sensitivity is 99 dB/mW and impedance is 40 ohms. Frequency response is 5 Hz - 42 kHz, and maximum input is 2,000 mW. Weight is approx. 395 g without the cable. Both housings have A2DC connector jacks. Two detachable 3.0 m cables are included, one with a gold-plated 6.3 mm stereo plug and one balanced cable with a 4-pin XLR-M connector.

Engineering and use context

Each driver has a strong magnet and an integrated pure iron yoke for improved transient response. Its diaphragm carries a DLC (Diamond-like Carbon) coating for the high frequencies. The bobbin-wound voice coil is high-purity 6N-OFC copper of 99.99997 percent.

Audio-Technica's D.A.D.S. (Double Air Damping System, PAT.) is the double construction used in its closed headphones. Two spaces of different size inside the acoustic chamber act as an air spring for extended low frequencies.

Housings have a semi-gloss finish. The wood is polished several times to ever finer grades, and coating and drying are then repeated over a long period, all by hand, so the grain differs from one unit to the next. All wooden headphones of the line are assembled by hand by craftsmen at Audio-Technica's factories in Japan and pass strict inspection.

The A2DC connector has a tip of its own design to exclude dropouts and noise. OFC wire is used for the balanced cable. Arms are newly designed moulded magnesium alloy, and their mounting angle was set for the closed housings and earpads to improve fit, prevent sound leakage and raise the seal. Earpads with three-dimensional stitching and the headband are covered in synthetic leather.

Pairing

The 6.3 mm cable connects to the headphone output of a home amplifier. A headphone amplifier with a 4-pin XLR balanced output is required for the balanced cable. Replacement earpads (HP-AWAS) and replacement cords are sold separately.

Alternatives

The ATH-AWKG is another closed wooden model from Audio-Technica, with housings of Kurogaki persimmon.

Specifications

  • Model name

    ATH-AWAS

  • Transducer principle

    Dynamic or Isodynamic

  • Scheme

    Closed

  • Wearing style

    Over-ear

  • Frequency response low +/- 10dB (Hz)

    5

  • Frequency response high +/- 10dB (Hz)

    42 000

  • Max. sound pressure level (dBSPL (1 kHz @ 5% THD))

    N/A

  • Connection type

    Wired

  • Connector (mm)

    N/A

  • Sensitivity (dBSPL (1 kHz/ 1 mW)))

    99

  • Impedance (Ohm (1 kHz))

    40

  • Playback time (hours)

    N/A

  • Weight (g)

    395

  • Official link