The ATH-AP2000Ti is a closed dynamic headphone from Audio-Technica with housings of titanium, released in Japan on 19 October 2018. It is produced entirely in Japan and assembled one unit at a time, and each headphone has its own serial number marked on the inside of the headband. A semi-hard case covered in sheepskin is supplied for transport and storage.
Key specs that matter
Type is closed dynamic with a newly developed 53 mm driver. Sensitivity is 100 dB/mW and impedance is 44 ohms. Frequency response is 5 Hz - 50 kHz, and maximum input is 2,000 mW. Weight is approx. 300 g without the cable. Both housings have A2DC connector jacks. Three detachable cables come in the box - 1.2 m and 3.0 m cords with a gold-plated 3.5 mm L-type stereo mini plug and a 1.2 m balanced cable with a gold-plated 4.4 mm five-pole L-type plug - together with a 6.3 mm stereo adapter and a cleaning cloth.
Engineering and use context
Inside the driver, a magnetic circuit of Permendur transmits the force of the magnet without loss. It works with a pure iron yoke for improved transient response and an OFC-7N voice coil. Its diaphragm has a DLC (Diamond Like Carbon) coating for improved high-frequency characteristics.
Each housing is machined individually from high-lustre titanium and polished by hand, a material with low weight and high rigidity that suppresses unwanted resonance. A moulded baffle of hard PPS resin has high strength and suppresses unwanted distortion of the large driver, and the titanium and hard resin together suppress unwanted vibration in the housing.
Core Mount Technology (PAT.P) places the voice coil at the position that divides the acoustic space from ear to housing in half. Audio-Technica's D.A.D.S. (Double Air Damping System), used in its closed headphones, works as an air spring for the low frequencies, with the balance of front and rear chambers optimised for this driver.
Frame, arms and sliders are thin magnesium to reduce the weight above the housings. Earpads and headband are sheepskin over low-rebound material, with three-dimensional stitching for fit and seal. The A2DC cables use 6N-OFC wire in a star-quad twisted construction with separate left and right grounds to reduce crosstalk.
Pairing
The 3.5 mm cords connect to a 3.5 mm headphone output, and with the adapter to a 6.3 mm output. A 4.4 mm balanced output is required for the balanced cable. Replacement earpads (HP-AP2000Ti) and A2DC cables HDC113A/1.2, HDC114A/1.2 and HDC112A/1.2 are sold separately.
Alternatives
The ATH-AWKG is another closed dynamic model from Audio-Technica with 53 mm drivers, here in housings of Kurogaki persimmon wood.