Hifiverse

Power amplifiers stereo - Analog Domain The Isis M75D

Description, images, technical data and specifications

Analog Domain The Isis M75D
Image source - (c) Analog Domain

The Isis M75D is the stereo integrated amplifier of the Isis range from Analog Domain Audio GmbH, the company in Taufkirchen near Munich that Angel Despotov founded in early 2010. It combines a stepped analogue volume attenuator, remote control and preamplifier stage with the power section used in the matching Isis M75P power amplifier, and either model can be configured as a monoblock. In 2018 the M75D was priced at EUR 21,750 in the Netherlands, and the Mk2 version was later listed at EUR 20,990 including VAT in Germany.

Key specs that matter

Rated output is 2 x 250 W into 8 ohms and 2 x 400 W into 4 ohms (sine wave, rms). In bridge mode one unit gives 500 W into 8 ohms with music material, and the MK II manual lists 800 W into 4 ohms. Peak current is 50 A. Analog Domain quotes THD+N below 0.002% (20 kHz BW, 8 ohms, nominal power) and below -93 dBr at 1 W into 4 ohms, with output noise below 35 µV (20 kHz BW, rms). Damping factor is above 1000 (1 kHz, 4 ohm load). Power bandwidth is 5 Hz - 50 kHz (2 ohms, THD below 0.1%). Two balanced XLR inputs at 20 kohm and two RCA inputs at 10 kohm are provided, each RCA pair with a +8 dB gain switch, and maximum input level is 10 Vrms. Dimensions are 440 x 454 x 123 mm (W x D x H, including feet and rear handles) and weight is about 25 kg.

Engineering and use context

Operating mode is class AB+G. Analog Domain uses its own output stage topology, named the Excalibur, in place of the common emitter follower, and its proprietary DXDrive bias control makes this topology usable. According to the manufacturer, the Excalibur needs very little bias current to reach near class A performance and has very low output impedance. A tiered power supply in the MK II provides two voltages of each polarity, and a management circuit tracks the output signal and switches a rail to the higher voltage during a peak. Both power stages operate in inverse phase, with the right channel electrically inverting, so they draw current from opposite supply poles and no separate phase inverter stage is needed.

Volume is set by a precision analogue stepped attenuator matrix in 0.75 dB steps from -96 dB to 0 dB. This DC-coupled amplifier has no capacitors in the signal path and includes short-circuit, over-temperature, clipping and DC protection. Its mains switch is a thermal circuit breaker, and power draw is below 1 W in standby and 20 W at idle.

Pairing

Minimum rated load is 4 ohms in stereo and bridge mode, and impedance dips to 1.5 ohms are allowed. Five-pin XLR PRE-OUT and MAIN IN sockets allow bi-amping with a second amplifier or an external preamplifier. The matching power amplifier is the Isis M75P.

Alternatives

Analog Domain makes no other integrated amplifier, since its DX9 amplifiers are bridged power amplifiers.

Specifications

  • Model name

    The Isis M75D

  • Input sensitivity (mV)

    N/A

  • Input impedance (balanced) (Ω)

    N/A

  • Input impedance (single-ended) (Ω)

    N/A

  • Output impedance (balanced) (Ω)

    N/A

  • Output impedance (single-ended) (Ω)

    N/A

  • Max current (A)

    50

  • Output power (8Ω) (W)

    250

  • Output power (4Ω) (W)

    400

  • Gain (dBu)

    N/A

  • Frequency response low +/- 3dB (Hz)

    5

  • Frequency response high +/- 3dB (Hz)

    50 000

  • Signal to Noise Ratio (dB)

    N/A

  • Total Harmonic Distortion + Noise (0% global feedback) (%)

    N/A

  • Total Harmonic Distortion + Noise (100% global feedback) (%)

    <0,002

  • Max power consumption (W)

    N/A

  • Damping factor

    >1000

  • Dimensions (mm)

    440 x 454 x 123

  • Weight (kg)

    25

  • Official link

More components