The Allnic Audio L-9000 OTL/OCL comes from Kang Su Park, whose Korean firm designs and builds tube electronics, and it handles line-level sources only. In the Allnic preamplifier range it sits between the L-8500 and the L-10000, and its single-ended path runs without output transformers or output capacitors, so the final tubes drive the power amplifier directly. The US list price was USD 19,500, and Allnic gives two years of cover on the unit and one year on the stock tubes.
Key specs that matter
Three gain stages are fitted per channel, each using a pair of tubes - 6U8A in the first stage, 12AU7 in the second and 6080 in the third. Five stereo line inputs are provided, two on balanced XLR and three on single-ended RCA, and each channel has one direct-coupled RCA output plus two XLR outputs. Allnic specifies a voltage gain of 18 dB, an output impedance of 90 ohm and a frequency range of 5 Hz to 100 kHz. The chassis measures 430 x 180 x 400 mm (W x H x D), weighs 22 kg and is offered with silver or black panels.
Engineering and use context
Inside, the L-9000 splits into two mirror-image mono sections. The 6080 output stage is a push-pull SEPP circuit that Allnic calls a floating power supply design, intended to stop DC from building up in the signal path. Because direct coupling is not used on the balanced side, the XLR outputs pass through Allnic's own permalloy transformers. Volume is set by a motorised, oil-clutched bridged-T attenuator with 61 steps of 1.5 dB and a fixed impedance, which the maker says keeps both channels matched at any setting. A soft-start circuit applies high voltage to the plates only after the tubes have warmed up, and the patented Absorb GEL dampers sit on the tubes. Two illuminated meters at the lower corners of the fascia show the balance of the output tubes, each with a screw for bias adjustment beside it. The front panel carries Power, Line 1 to 5 and Mute buttons, while the master rocker switch and IEC inlet are on the left side panel. The supplied remote control has a heavy aluminium body.
Pairing
The low output impedance and direct-coupled RCA path allow the L-9000 to feed lengthy cable runs and amplifier inputs of fairly low impedance with no extra buffer stage. Owners of balanced power amplifiers get two transformer-isolated XLR feeds, handy for bi-amping or for running a subwoofer alongside the main amplifier. Turntable owners will need a separate phono stage for vinyl replay.
Alternatives
One rung lower sits the Allnic Audio L-8500 OTL/OCL, using four 12B4 output tubes in a 16 kg chassis.