The Allnic Audio L-8500 OTL/OCL is a remote-controlled tube line preamplifier with three gain stages, and it preceded the L-9000 in the catalogue of the Korean company. Its name refers to the output arrangement - no output transformer and no output capacitor stand between the final tubes and the power amplifier on the single-ended path. Its American list price stood at USD 13,500.
Key specs that matter
Eight tubes are used in total - two 6AN8, two 12AU7 and four 12B4, with the 12B4 pairs forming the output stage. Inputs come in both XLR and RCA form, with five stereo sources in all, and outputs are offered on XLR and RCA as well. Input impedance is 10 kohm, output impedance is 200 ohm and voltage gain is 18 dB. Allnic quotes a frequency range of 10 Hz to 90 kHz, total harmonic distortion below 0.03 % at 1 kHz and 1 V, a signal-to-noise ratio of 100 dB and a maximum output of 15 V RMS before clipping. Power draw is 120 W. The case measures 430 mm wide, 160 mm high and 380 mm deep, with a weight of 16 kg.
Engineering and use context
Allnic separates the left and right signal paths in a dual-mono layout, and each 12B4 pair runs as a single-ended push-pull (SEPP) circuit. A 6AN8 pentode controls an active balanced feedback loop that mixes positive and negative feedback and governs the operation of the gain stages. According to Allnic, its floating power supply circuit keeps DC potential out of the signal path. Level is adjusted by a stepped Silver Contact Constant Impedance attenuator that is driven from the remote control. High voltage reaches the tubes through a delayed soft-start stage only once the heaters have brought the tubes up to temperature, and the patented Absorb GEL tube dampers are there to cut microphonic noise. Two analogue meters monitor the output tubes, and a bias control sits next to them for each channel. NOS tubes are fitted where Allnic considers it sensible, the IEC socket and rocker switch are on the side of the case, and a 90-degree mains cable comes in the box.
Pairing
With a low output impedance and plenty of voltage swing in reserve, the L-8500 copes with amplifiers that need a large input signal and with long interconnects. Both balanced and single-ended amplifiers can be used, and the mixed input set accepts DACs and phono stages with either connector type.
Alternatives
Above both the L-8500 and the L-9000, the Allnic Audio L-10000 OTL/OCL is the dearer line stage in the range, priced at USD 30,000.