The Allnic Audio L-7000 is a dual-mono tube line preamplifier from the Korean company Allnic Audio, introduced at the end of 2017 at USD 14,900 and later priced at USD 16,200 in the American market. Each channel has a single gain stage, and the left and right circuits share only the chassis and the AC inlet. Its most unusual feature is the use of the 300B, which sits in the power supply as a voltage regulator and never in the audio path. It came in silver or black.
Key specs that matter
Three RCA and two XLR input pairs present 10 kOhm, while the outputs, one RCA and two XLR pairs, have an output impedance of about 150 Ohm that Allnic keeps constant across frequency. Gain is 20 dB. Frequency response is flat from 20 Hz to 20 kHz and reaches 16 Hz to 50 kHz at -3 dB. Total harmonic distortion is 0.06% at 0.3 V output and 0.15% at 1.0 V output, both at 1 kHz, with a 90 dB unweighted signal-to-noise ratio. Its case is 430 mm wide, 410 mm deep and 173 mm tall, with a weight of 18 kg.
Engineering and use context
The L-7000 carries six tubes in total. Two E810F tubes handle gain, two 300B triodes regulate the supply voltage, and two 5654 tubes complete the regulation circuit. Allnic chose the gain tubes for high transconductance, low internal resistance and high amplification factor, and the regulated supply holds deviation below 1%. Instead of coupling capacitors the L-7000 uses transformers built in-house on nickel-iron Permalloy cores, and the class A circuit is free of negative feedback. Level is controlled by a motorized constant-impedance attenuator with a single contact path, which Allnic uses to keep the two channels matched at any setting, and its motor drive works through an oil clutch. The company's Absorb Gel damping is applied to the tubes. Control is via an aluminium remote, and the chassis has no mains power switch.
Pairing
A line stage with a balanced output pair to spare lets one stereo amp and a powered subwoofer or second amp be connected together, and its steady low source impedance copes with long interconnects. The L-7000 has no phono input, so record playback calls for a separate phono stage. Any tube or transistor power amplifier with a conventional input sensitivity suits its gain, and amplifiers fitted with XLR sockets can take its signal over a fully balanced connection.
Alternatives
The Allnic Audio L-8000 DHT is a more expensive line preamplifier of the brand that uses directly heated triodes in every gain stage and tube-regulated supplies.