Hifiverse

Non-Oversampling (NOS) DAC

A non-oversampling (NOS) DAC converts each digital sample to voltage at its original rate, with no upsampling stage and no digital filter. Designers choose it to avoid the pre-ringing that steep digital filters add, accepting a gentler analog roll-off in exchange for simpler conversion.

What a NOS DAC is & why it matters

Most converters multiply the sample rate and apply a sharp digital low-pass filter before conversion. A NOS design feeds samples straight to the chip, so the mirrored spectrum above half the sample rate has to be handled by an analog filter or left in place. Higher input rates push those mirrors further out of the band. The practical benefit is a short signal path with fewer processing stages.

What you'll find in this tag

The tag gathers launch news on converters built around non-oversampling operation. The current entry covers the Core Audio DENPO, a single-chip DAC that runs a ROHM BD34301 from the MUS-IC series in NOS mode without an FPGA. The story details its XMOS USB input with reclocking, a seven-section linear power supply and support for PCM up to 24-bit/384 kHz plus native DSD256.

Key models & chips to know

Core Audio DENPO - aluminum case, full RFI shielding and twin transformers splitting the digital and analog supplies. ROHM BD34301 - the Japanese 32-bit converter chip inside the DENPO. XMOS USB receiver - the interface chip that feeds the DENPO. Triple GND layout - the grounding scheme Core Audio uses to keep noise away from the converter. Many NOS designs also rely on resistor ladders instead of chips.

Related topics & where to go next

Read R-2R Ladder DAC for resistor-ladder converters and Ring DAC for another discrete approach. High-Resolution Audio (Hi-Res) explains the sample rates involved, and new converter launches arrive in the news feed.