The Carnegie is rated at 97 dB into 8 ohm with a frequency range of 26 Hz to 29 kHz, figures that let a few watts reach realistic levels. The tweeter is a 1 inch ring-radiator compression driver with a 38 mm Mylar diaphragm and a neodymium magnet giving 2.4 Tesla in the gap, loaded by a 42 cm spherical-wave horn of layered birch plywood. A 13 cm midrange sits below it, and the bass comes from a 38 cm Audax paper woofer on an oversized ferrite magnet, working into a 60 cm waveguide. Crossover points sit at 420 Hz and 2,200 Hz, and the crossover is hand-wired point to point. All drivers lie on one axis for consistent phase, and the cabinets are built from 24 mm multiplex. A downfiring bass reflex port excites room modes less than a rear port aimed at the wall behind the speaker. Taken together, the light woofer cone, the horn loading and the benign load mean that single-ended triodes such as 300B or 2A3 designs are a natural partner, while larger solid-state amplifiers run with ample reserve.
How it sounds
With the woofer and horn doing most of the work, the pair produces large scale at moderate drive, and the presentation fills the room with a strong sense of presence. Because the downfiring port loads the floor rather than the rear wall, bass stays more even across listening positions, and the single-axis layout keeps voices coherent from top to bottom.
by Odeon Audio
The top-end ODEON Audio Carnegie speakers flaunt 97 dB sensitivity and work great with low-power tube amplification. A 38 mm mylar compression tweeter with a 2.4Tesla magnetic system, a 13 cm midrange driver and a 38 cm woofer are all enclosed in branded horns made of multilayer wood composite.