Hifiverse

Synthesis Soprano II - Tube Integrated Amplifier with 32-bit DAC

Synthesis Soprano II - Tube Integrated Amplifier with 32-bit DAC
Stas Ustenko
Stas Ustenko

15.11.2026 12:37 | ~2 min read

The Italian company Synthesis has announced Synthesis Soprano II - the second version of its junior tube integrated amplifier. The final stage on the EL84/6BQ5 remains the same, but the power supply, transformers, digital part and set of inputs have been significantly redesigned.

Synthesis Soprano II
Synthesis Soprano II. Image source - (c) Synthesis

The output stage circuit of the Synthesis Soprano II is well known from the original Soprano - this is a push-pull ultra-linear switch operating in class A. A pair of EL84/6BQ5 is installed in each channel, the power is 2 x 12 W RMS into a 6 Ohm load. The declared frequency response is from 20 Hz to 20 kHz with unevenness ±0.5 dB, harmonic distortion is 1% at full power at a frequency of 1 kHz.

The main changes to Synthesis Soprano II relate to power supply. DACs and operational amplifiers are now powered by LDO stabilizers with high ripple suppression, and the filters contain electrolytic capacitors with ultra-low ESR. The power transformer with an EI core is made of M6 anisotropic steel. The output transformers are also new, with anisotropic silicon steel plates - they have a higher primary inductance and saturation threshold, which should give deeper and more collected bass.

The digital path uses a 32-bit AKM DAC. There are two S/PDIF inputs - coaxial and optical - but the company abandoned the USB interface that its predecessor had (instead, a second linear input was added). Sales of Synthesis Soprano II will begin in February 2027.

Comments