The Schröder CB-9 is a tonearm designed by Frank Schröder and offered by Dohmann Audio, listed alongside the longer CB-11. Schröder conceived the CB range in parallel with the Dohmann Helix One turntable. CB stands for Captive Bearing. Unlike the magnetic bearing for which Schröder holds worldwide patents, the CB series uses hybrid ceramic bearings.
Key specs that matter
Arm wand length is 229 mm and effective length 239.3 mm, with a pivot to spindle distance of 222.0 mm, 17.3 mm overhang and a 23° offset angle. Effective mass is 14 g with the supplied cartridge mounting plate, 19 g with the optional heavy plate and 12.5 g with the optional ultra-light plate. Bearing friction is 2 mg vertically and 3.5 mg horizontally, which Dohmann calls the lowest measured friction of any traditional bearing arm. Shaft diameter is 23 mm, and the mounting surface sits 25 - 60 mm below platter level, best about 30 - 35 mm. Arm wands come in carbon fibre or Kingwood, with black metal parts. Its wiring is cryogenically treated, low loss, high purity copper in a single run from the cartridge clips to the RCAs, 1 m from arm to RCAs, with other lengths on request.
Engineering and use context
Magnetically centred and pre-loaded ceramic hybrid ball bearings eliminate bearing chatter. Lateral movement is damped by eddy current induction, and the bearing for vertical movement lies on the same plane as the record, so warp wow does not affect the arm. Mass is distributed symmetrically around the central bearing axes. VTF stays unchanged when VTA or record thickness is altered, and a calibrated centre post allows repeatable VTA adjustment.
Inside the arm, defined physical zones focus vibrations away from key areas, and energy from the motor, plinth and bearing that arrives through the mounting plate is diverted away from the critical path. A multi-layer wand of carbon fibre and other composites combines torsional and bending stiffness with high internal damping. Each counterweight has two sections and an adjustable damping system. Its lower cylinder can be exchanged for a lighter or heavier one without altering the mass distribution, for an arm and cartridge resonance of 8 - 12 Hz. VTF, VTA, overhang, offset angle and azimuth are adjustable. Anti-skating is magnetic, up to 2.3 g, and an exchangeable anti-skating screw covers higher tracking forces on request.
Pairing
An armboard with a 24 - 25 mm mounting hole and a single M6 tapped hole is required. The three mounting plates cover cartridges from high to low compliance. Low dielectric loss wiring allows any MM cartridge with the correct capacitive load at the phono stage.
Alternatives
The Schröder CB-11 is the longer model of the same CB series, with an effective length of 282.0 mm.