The Schröder CB-11 is the long tonearm of Frank Schröder's CB series, offered through Dohmann Audio of Australia with a 305 mm arm wand. CB stands for Captive Bearing. Unlike the magnetic bearing principle for which Schröder holds worldwide patents, the CB arms use hybrid ceramic bearings. The shorter CB-9 completes the series.
Key specs that matter
Effective length is 282.0 mm and pivot to spindle distance is 267.5 mm, with 14.52 mm overhang and a 19.35 degree offset angle. Bearing friction is quoted at 2 mg vertical and 3.5 mg horizontal. Effective mass is 18 g with the supplied cartridge mounting plate, 23 g with the optional heavy plate and 16.5 g with the optional ultra-light plate. The 23 mm shaft mounts in a 24-25 mm hole with a single M6 tapped hole. Distance between mounting surface and platter level is 25-60 mm, best about 30-35 mm. The wand is carbon fibre or kingwood, and the metal parts are black.
Engineering and use context
The ceramic hybrid ball bearings are magnetically centred and pre-loaded to eliminate bearing chatter, and Dohmann Audio calls their friction the lowest measured on any traditional bearing arm. Lateral movement is damped by eddy current induction. Its vertical bearing lies on the same plane as the record. Mass balance is set so that VTF does not change when VTA or record thickness is altered, and a calibrated centre post allows repeatable VTA adjustment.
Inside the structure, defined physical zones divert vibration from the motor, plinth and bearing away from the critical path. Mass is distributed symmetrically around the central bearing axes to prevent cantilever deflection by external excitation. The multi-layer wand combines carbon fibre with other composites for torsional and bending stiffness and high internal damping.
Adjustable parameters are VTF, VTA, overhang, offset angle and azimuth. Anti-skating is magnetic and frictionless, up to 2.3 g, and a different anti-skating screw for higher tracking forces is available on request. A dual section counterweight has an adjustable damping system, and its lower cylinder can be exchanged for a lighter or heavier one without altering the mass distribution. Wiring is cryogenically treated high-purity copper in a single run from the cartridge clips to the RCAs, 1 m long, with other lengths on request.
Pairing
Schröder targets an arm and cartridge resonance of 8-12 Hz. Low dielectric loss wiring allows any MM cartridge with the proper capacitive load at the phono stage. An armboard cut for a long arm is required.
Alternatives
The Schröder CB-9 has the same bearings and adjustments on a 229 mm wand with an effective length of 239.3 mm.