Hifiverse

Tonearms — European Audio Team (EAT) C-NOTE 10"

Description, images, technical data and specifications

European Audio Team (EAT) C-NOTE 10"
Image source - (c) European Audio Team (EAT)

The C-Note 10-inch is a tonearm from European Audio Team (EAT), the analogue company based in Lucenec, Slovak Republic, and each arm is handcrafted there. EAT describes the C-Note as a completely new design that combines a unipivot with a cardan bearing. It is made in three versions - 12, 10 and 9 inches - and the 10-inch sits between the other two in length.

Key specs that matter

Effective length is 254 mm and pivot to spindle distance is 238 mm. Overhang is 16 mm and the offset angle is 21.4°. Effective tonearm mass is 16.5 g. Null points are at 126.8 mm and 248.2 mm. Tracking force range is 0-3 g, and the mounting slots in the headshell have a 12.7 mm pitch. A two-part counterweight balances cartridges from 5 to 9 g (125 g counterweight) or from 8.5 to 13 g (142 g with the additional insert).

Engineering and use context

In this bearing the central uni-pivot only reduces the load on the bearing, while the cardan section gives stability, ease of use and very low friction. Both bearings are immersed in a damping fluid. EAT states that the silicon-based grease inside the arm damps tonearm and cartridge resonances by more than 50%.

A stiff, rigid carbon arm tube carries an aluminium headshell. EAT chose light, rigid aluminium for its inner damping and because it allows tighter mounting of high-end MC cartridges.

Azimuth is set at the factory. To change it, the azimuth set screw under the uni-pivot cover is loosened and the arm tube is rotated. VTA is adjusted by loosening two hexagonal screws in the tonearm base and sliding the arm pillar up or down. Anti-skating uses a weight on a thread, with a sliding mechanism on a support rod. Its weight sits in one of three grooves according to tracking force - the first below 1.3 g, the second for 1.3-1.8 g and the third for 1.8-2.5 g. Cartridge pins are wired white L+, red R+, green R- and blue L-. Signal leaves through a 5-pin tonearm connector, and the tonearm cable and a two-point alignment protractor are supplied with the accessories.

Pairing

A turntable with an armboard drilled for the 10-inch C-Note mounting distance and a 5-pin tonearm socket is required. A cartridge within the weight range of the two counterweight options is required. With an MC cartridge in the aluminium headshell, a phono stage with an MC input is required.

Alternatives

The EAT C-Note 12-inch is the longer version of the same arm, with 304.8 mm effective length and 19.2 g effective mass.

Specifications