Klipsch introduced the R-121SW with the 2021 generation of its Reference series, where it is the 305 mm subwoofer next to the 254 mm R-101SW. It succeeds the R-120SW, and the main change is the cone material - spun-copper TCP in place of the earlier IMG. The amplifier is all-digital, and the cabinet is reflex-loaded MDF with a front-firing driver.
Key specs that matter
Its driver is one 305 mm high excursion spun-copper TCP woofer. Amplifier power is 200 W continuous and 400 W peak, from an all-digital amplifier. Frequency range is 28 Hz - 120 Hz, and maximum acoustic output is 118 dB. Enclosure type is bass reflex via a rear-firing port. Inputs are line level/LFE RCA jacks. Dimensions are 421 x 406 x 500 mm (H x W x D), and weight is 16.0 kg. Finish is black textured wood grain vinyl.
Engineering and use context
TCP stands for Thermoformed Crystalline Polymer. Klipsch describes the material as light, rigid and tightly packed, with minimal cone breakup and distortion without degradation, and calls these woofers revamped. Construction is reinforced 19 mm MDF, and a new bracing design reduces cabinet vibration. Outside, the cabinet has a scratch-resistant textured wood grain vinyl and a low profile grille.
Amplifier controls are volume, low-pass and 0/180 degree phase. When the crossover point is set in the receiver, Klipsch specifies the low-pass knob at its farthest point right (160 Hz). An Off/Auto/On switch sets the power mode. In Auto the R-121SW turns on when it senses a signal and goes into standby mode after 15-20 minutes with no signal. In the On position it stays on until switched to another setting. An LED on the front baffle shows the status of the built-in amplifier and lights green while it is on and receiving a signal.
Two RCA line inputs are marked LEFT/LFE and RIGHT. One subwoofer cable from the Sub Out or LFE output to the LEFT/LFE input covers both music and surround sound. Left and right pre-amp outputs can go to both inputs when no subwoofer output exists.
Pairing
A receiver, processor or preamplifier with a subwoofer pre-out or left and right pre-outs is required. Speaker-level inputs are not provided. The matching main speakers are the Klipsch Reference models of the 2021 generation.
Alternatives
The Klipsch R-101SW is the smaller TCP subwoofer of the same 2021 Reference generation, with a 254 mm woofer.