The HDI-1200P is a 300 mm powered subwoofer from JBL, the Harman brand based in Northridge, California, where it was designed and engineered. JBL presents it as the foundation of a complete HDI Series surround system, and its documents carry the JBL Synthesis name. Finishes are automotive-grade painted High Gloss Black and furniture-grade satin Walnut or Gray Oak wood veneer.
Key specs that matter
Amplifier - 1,000 W RMS, Class D. Driver - 1 x 300 mm black Poly-plas cone, cast-frame woofer with a 76 mm voice coil. Frequency response is 28 Hz - 150 Hz (-6 dB). Low-pass crossover is 50 Hz - 150 Hz (variable), 24 dB/octave. Inputs are balanced XLR and unbalanced RCA, 0 dBV nominal, +12 dBV max unbalanced and +18 dBV max balanced. Power requirement is 100 V - 240 V, 50/60 Hz, with under 0.5 W in standby and 1180 W max at 230 V (1230 W at 120 V, 1190 W at 100 V). Dimensions are 430.5 x 414 x 451.3 mm (H x W x D), weight 31.79 kg.
Engineering and use context
Its enclosure is heavily braced and bass-reflex loaded, with dual down-firing, computer-optimized flared ports. A black cloth grille is attached magnetically. On the rear panel there are gain and low-pass crossover controls, a phase switch and a single-band parametric EQ with its own on/off switch. EQ frequency runs from 32 Hz to 100 Hz, bandwidth from 0.1 to 0.6 octave and level from -12 dB to +3 dB. For a processor with a low-pass filtered subwoofer output, the crossover knob has an LFE position. Either the left or the right input can be used, and the XLR input is wired pin 2 hot.
Power Mode offers Auto, On and Trigger. In Auto the subwoofer turns on when an audio signal is detected and returns to standby after about 10 minutes without one, and its LED glows green when on and red in standby. In Trigger mode it turns on when 5 V - 12 V is present at the 12V Trigger In connector. Whenever it is on, 12 V is available at the 12V Trigger Out connector for additional HDI-1200P subwoofers or another triggerable device. A red flashing LED indicates protection mode. Supplied with it are a combination LFE and trigger cable with a 3.5 mm plug and four metal carpet spikes.
Pairing
The matching loudspeakers are the HDI Series models. A surround processor or preamplifier with a balanced or single-ended line-level subwoofer output is required. A processor trigger output with a 3.5 mm mini jack connects to the 12V Trigger In through the supplied cable.
Alternatives
In the JBL Stage line the 220P is a 300 mm powered subwoofer rated at 250 W RMS.