The F3-12 is the largest of the three F3 Series subwoofers from Fyne Audio, above the F3-8 and F3-10. Fyne intends it for both music and film, with a Bass Boost mode for home theatre LFE. It was sold at GBP 999.98 per unit in Black Ash, and Fyne now lists it among its discontinued models.
Key specs that matter
Its 300 mm multi-fibre cone driver is powered by a 520 W DDX Direct Digital amplifier. Enclosure type is vented, down-firing, and enclosure volume is 53 litres. Low frequency response is 28 Hz (-6 dB, typical in room). Bass Boost raises output by 3 dB over 30 - 70 Hz. Inputs are 2 x phono L & R stereo and 1 x mono LFE, and the input filter is an 80 Hz 2nd order low pass with LFE provision. Mains voltage is 220 - 240 V, 50/60 Hz, or 100 - 120 V, 60 Hz for the US version, with maximum power consumption of 260 W and standby consumption below 0.5 W (ErP). Dimensions are 480 x 375 x 443 mm (H x W x D, including feet), and net weight is 20 kg.
Engineering and use context
Fyne calls DDX a patented, all-digital, high efficiency amplifier technology. Compared with a standard Class D amplifier, the company quotes higher power, better efficiency and lower RFI output. Inside, the DSP engine controls the low pass filters on both the LFE and stereo inputs, automatic dynamic range management and overload protection, and enables Bass Boost.
A unique mix of fibres forms the cone, giving a light and stiff diaphragm. Excursion and power handling come from a soft rubber roll surround and a deep coil and motor assembly. Heavily built, the cabinet uses high rigidity braced MDF panels. Its large diameter port is flared at both ends to a mathematically derived profile for low turbulence, and compliant floor coupling mounts sit underneath.
The amplifier panel carries the controls - sub level, phase (0 or 180 degrees), Bass Boost, input mode and power mode. Selecting NORMAL brings in the internal 80 Hz low pass filter, while LFE bypasses it so that the filtering of the AV receiver is used. In AUTO mode the F3-12 powers on when it detects a signal and enters standby again after approximately 10 minutes without one. In ON mode it stays permanently powered. Remote switching uses a 12 V trigger input, a standard 3.5 mm jack with positive centre pin.
Pairing
The SUB OUT of an AV receiver connects to the mono LFE input in LFE mode. For a two-channel system, a spare pair of preamplifier outputs connects to the left and right phono inputs in NORMAL mode. A receiver with a 12 V trigger output can switch the subwoofer on.
Alternatives
The F3-10 is the smaller F3 Series subwoofer, with a 250 mm driver, a 475 W DDX amplifier and a 34 litre enclosure.