The ASW608 is an active closed-box subwoofer from Bowers & Wilkins and the most compact of the three ASW Series models, below the ASW610 and ASW610XP. All three are covered by one owner's manual dated May 2013, and the information sheet lists them as the subwoofers of the 600 Series. US price is USD 700.
Key specs that matter
Its drive unit is a 200 mm long-throw unit with a paper/Aramid fibre cone. Amplification is a 200 W (rated power) ICEpower Class D amplifier. Frequency response is 32 Hz - 40/140 Hz adjustable (±3 dB, EQ at A). Bass extension is -6 dB at 23 Hz in position A, 28 Hz in position B and 36 Hz in position C. Power consumption is 40 W, 0.5 W in standby. Input impedance is 33 kohms and signal/noise is >90 dB. Height is 260 mm without feet or spikes (272 mm on feet, 288 mm on spikes), width is 260 mm and depth is 305 mm (330 mm with grille and controls). Net weight is 8.85 kg.
Engineering and use context
Bowers & Wilkins designed the subwoofer both for home theatre LFE duty and for extending the bass of full-range speakers in 2-channel systems. On the rear panel are a stereo line input on RCA sockets, speaker-level binding posts and a 3.5 mm jack for the 12 V trigger, each signal input with its own volume control. The low-pass filter is an active 4th-order type with variable cut-off frequency. Its bypass switch applies to the line input only, and the filter is always in circuit with the speaker-level input.
A three-position bass extension switch is provided. Position A gives the greatest extension, C the least and B sits between them, and Bowers & Wilkins recommends B or C for very high volume levels. A separate two-position EQ switch, A or B, alters the bass roll-off alignment. Phase is switched between 0 and 180 degrees.
With the power switch at On, the ASW608 stays active. At Auto it enters sleep after about 5 minutes without an input signal and wakes when a signal is detected. At Standby it becomes active when 12 V is applied to the trigger input and returns to sleep at zero volts. A status indicator glows green when active and red in sleep. Supplied parts are a mains cable, four M6 spike feet, four M6 rubber feet and four lock nuts. The front grille is removable. Cabinets come in black or white, with a black or grey grille.
Pairing
The matching speakers are the 600 Series models. An AV processor connects to the line input with the low-pass filter switched out. A stereo amplifier without a subwoofer output connects through the speaker-level binding posts.
Alternatives
The Bowers & Wilkins ASW610 is the next ASW model, with a 250 mm long-throw unit and the same 200 W amplifier.