Hifiverse

Floorstanding loudspeakers — Apertura Audio STELA

Description, images, technical data and specifications

Apertura Audio STELA
Image source - (c) Apertura Audio

The Stela is a compact floorstanding loudspeaker from Apertura, the French company of designer Christian Yvon, hand-built near Nantes. It completes Apertura's range of three compact speakers with the Swing and Sensa. Compared with them it has a 2-way, 3-driver layout, and Apertura specifies a higher level of bass response and dynamic capability. It was shown at High End Munich in a metallic green version.

Key specs that matter

Drive units are two 16 cm Seas bass-midrange drivers with Isotactic Matrix cones and one 25 mm Ring Radiator tweeter with a double ferrite magnet. Crossover frequency is 3.4 kHz. Loading is bass reflex with a rear vent tube. Frequency range is 40 Hz - 30 kHz (±3 dB). Sensitivity is 88 dB (2.83 V/1 m), and impedance is 8 ohms nominal, 6 ohms minimum. Dimensions are 230 x 310 x 970 mm (W x D x H) with stand and spikes, and weight is 19 kg.

Engineering and use context

Apertura uses a special version of the woofers that keeps the Stela at a nominal 8 ohms with two bass-midrange units. Their cones are a composite of woven coated polypropylene tapes. In each driver the magnetic circuit concentrates the flux on a 26 mm voice coil, and the coil is ventilated against compression between the phase plug and the pole piece. Radial reinforcements in the low-loss rubber surround act against break-up modes. The Ring Radiator tweeter extends beyond 30 kHz, and a rear wave damping cavity lowers its resonant frequency.

The Stela has a passive crossover of the proprietary DRIM type, with attenuation slopes of 6, 12 and 24 dB per octave and phase compliance over the whole bandwidth. It is wired by hand at the Puceul facility on a printed circuit board with 140 µm copper. Components are enamelled-wire inductors, polypropylene capacitors and wound resistors, and internal wiring is heavy-gauge OFC cable.

An 18 mm MDF cabinet is stiffened by four internal bracing panels. These panels also form cavities for the damping materials, of which four different types are used. A base plate and four adjustable spikes carry the cabinet. Finishes are satin light oak and American walnut, and high-gloss white and piano black.

Pairing

An amplifier stable into 6 ohms is required. The base plate and spikes come with the speaker.

Alternatives

The Edena Evolution is a larger two-way floorstanding speaker from Apertura, with a 22 cm mid/woofer and a ribbon tweeter.

Specifications

  • Model name

    STELA

  • Frequency Response low +/- 3dB (Hz)

    40

  • Frequency Response high +/- 3dB (Hz)

    30 000

  • Sensitivity (dB at 1 W/1m)

    88

  • Impedance (Ohms)

    8

  • Power amplifier requirements (W)

    N/A

  • Has internal amplification

    N/A

  • Internal amplification power (W)

    N/A

  • Size (sm)

    23.0 x 31.0 x 97.0

  • Weight (kg)

    19

  • Official link

More components