Hifiverse

Floorstanding loudspeakers — Wharfedale DIAMOND 12.4i

Description, images, technical data and specifications

Wharfedale DIAMOND 12.4i
Image source - (c) Wharfedale

The Diamond 12.4i is the larger of two floorstanding loudspeakers in Wharfedale's Diamond 12i series, the update of the Diamond 12 series launched in 2020. For the 12i version Wharfedale added three new finishes and revised the bass port design and internal damping, while the Klarity mid/bass cones were carried over unchanged. Port development was led by Director of Acoustic Design Peter Comeau with senior engineers Dan Bailey Ornellas and Oliver Davies.

Key specs that matter

This is a 2.5-way bass reflex floorstanding speaker with two 150 mm (6.5 in) advanced PP cone drivers, one for bass and one for midrange, and a 25 mm (1 in) textile dome tweeter. Crossover frequency is 2.1 kHz. Frequency response is 40 Hz - 20 kHz (±3 dB), with bass extension to 35 Hz (-6 dB). Sensitivity is 89 dB (2.83 V/1 m) and peak SPL is 102 dB. Impedance is 8 ohms compatible, 5.0 ohms minimum, and recommended amplifier power is 30 - 200 W. Cabinet volume is 40.8 litres. Dimensions are (1100+50) x 200 x (350+28) mm (H x W x D), and net weight is 22.4 kg.

Engineering and use context

Wharfedale tuned the new port with laser interferometry, anechoic and in-room measurements and computational fluid dynamics (CFD) of airflow and pressure. Klarity is a blend of polypropylene and mica, with a low-damping surround and ribbed cone shaping. Each mid/bass magnet system has an aluminium compensation ring to reduce the effect of inductance changes as the voice coil moves, and the coil is wound on an epoxy/glass fibre bobbin.

Its tweeter is a woven polyester dome with a high-loss damping coating, set in a flat front plate with a minimal waveguide. A Linkwitz-Riley crossover uses air-core inductors, and the mid/bass magnet structure is modified to address their resistance. Enclosures are a multi-layered sandwich construction with acoustically tested adhesive between the layers, and computer-modelled spot braces connect opposite cabinet walls. Spikes with locknuts thread into inserts in the plinth. Finishes are All-Black semi-matte, Classic Walnut with a semi-matte black baffle, and Stone Grey.

Pairing

An amplifier rated for 8 ohm loads is required. Its screw terminals take bare cable ends. The Diamond 12 3Di surround is designed to sit on top of the 12.4i.

Alternatives

The Diamond 12.3i is the smaller floorstanding speaker in the Diamond 12i series.

Specifications

Related content

More components